MUNBYN IPDA050 User manual

IPDA050 User Manual

1
Contents
Chapter 1 Brief Introduction.........................................................................3
1.1 Brief Introduction................................................................................3
1.2 Precaution Before Using Battery......................................................4
Chapter 2 Installation Guide........................................................................ 6
2.1 Appearance..........................................................................................6
2.2 Buttons..................................................................................................7
2.3 Micro SD, SIM, PSAM Card Installation......................................... 7
2.4 Battery Charging................................................................................. 7
2.5 Device Power on/off........................................................................... 8
Chapter 3 Call Function................................................................................8
3.1 Phone....................................................................................................8
3.2 Contacts................................................................................................9
3.3 Messaging............................................................................................ 9
Chapter 4 Barcode Reader........................................................................10
Chapter 5 RFID Reader............................................................................. 11
5.1 High Frequency.................................................................................11
5.1.1 14443A........................................................................................11
5.1.2 14443B........................................................................................12
5.1.3 15693...........................................................................................12
5.2 NFC..................................................................................................... 13
Chapter 6 Other Functions........................................................................ 13
6.1 PING................................................................................................... 13
6.2 Bluetooth............................................................................................ 14
6.3 GPS.....................................................................................................15
6.4 Volume Settings................................................................................16
6.5 Sensor.................................................................................................17

2
6.6 Keyboard............................................................................................ 17
6.7 Network...............................................................................................17
Chapter 7 Device Specifications...............................................................18

3
Chapter 1 Brief Introduction
1.1 Brief Introduction
IPDA050 is a series of Android powered smart terminals, with data
capture, data processing, wireless communication. Auto & Accurate
data collection is achieved in various business fields via a complete
solution of premium options, the flexible solution among options and
operators is suited-up. You will find out with IPDA050, much easier
deployment, reduced complexity, decreased maintenance, are the
benefits for enterprises.
IPDA050 meets industrial level IP65 (IEC sealing), is sufficient to
routine applications, railway inspection, road parking toll, vehicle
inspection, logistics express, power inspection, warehousing
management, chain retail, etc. Whether the mobile operators are
working indoor or outdoor, with IPDA050, your business is always
&highly efficient on-line.
Meeting industrial standards, designed to support various of mobile
solutions. With the build-in high performance Cortex-A7 1GHZ quad
core processor technology, the operators need only one device to
enjoy a convenient and easy job, IPDA050 will be the ideal choice for
key-fact business in mobile solutions, for simplified task flow,
enhanced work efficiency, for shortened time to customer response,
more satisfied customer care service.
IPDA050 comes with world wide band 4G technology. Multi channels
data and voice communication guarantees the real-time
communication and data efficiency.

4
1.2 Precaution Before Using
Battery
When you use IPDA051 for the first time,
please make sure the insulation sticker on the
battery has been removed.
Do not leave batteries unused for extended periods of
time, either in the product or in storage. When the battery has
been unused for 6 months, check the charge status and charge
or dispose of the battery as appropriate.
The typical estimated life of a Lithium-Ion battery is about
two to three years or 300 to 500 charge cycles, whichever
occurs first. One charge cycle is a period of use from fully
charged, to fully discharged, and fully recharged again. Use a
two to three year life expectancy for batteries that do not run
through complete charge cycles.
Rechargeable Lithium-Ion batteries have a limited life and
will gradually lose their capacity to hold a charge. This loss of
capacity (aging) is irreversible. As the battery loses capacity,
the length of time it will power the product (run time) decreases.
Lithium-Ion batteries continue to slowly discharge (self-
discharge) when not in use or while in storage. Routinely check
the battery’s charge status. The user manual typically includes
information on how to check battery status, as well as battery
charging instructions.
Observe and note the run time that a new fully-charged
battery provides for powering your product. Use the new battery
run time as a basis to compare run times for older batteries.
The run time of your battery will vary depending on the
product’s configuration and the applications that you run.

5
Routinely check the battery’s charge status.
Carefully monitor batteries that are approaching the end
of their estimated life.
Consider replacing the battery with a new one if you note
either of the following conditions:
The battery run time drops below about 80% of the
original run time.
The battery charge time increases significantly.
If a battery is stored or otherwise unused for an extended
period, be sure to follow the storage instructions in this
document. If you do not follow the instructions, and the battery
has no charge remaining when you check it, consider it to be
damaged. Do not attempt to recharge it or to use it. Replace it
with a new battery.
Always follow the charging instructions provided with your
product. Refer to your product’s user manual and/or online help
for detailed information about charging its battery.
Charge or discharge the battery to approximately 50% of
capacity before storage.
Charge the battery to approximately 50% of capacity at
least once every six months.
Remove the battery and store it separately from the
product.
Store the battery at temperatures between 5 °C and 20 °C
(41 °F and 68 °F).

6
Chapter 2 Installation Guide
2.1 Appearance
The IPDA050 device has black and white appearance optional.

7
2.2 Buttons
Button
Function
Power Button
Press and hold to turn the device on or
off.
Custom Function Button
Customize function by software
SCAN
Scan Button
X
Cancel Button
Num
Switch white keyboard function
Fn
Switch orange keyboard function
Setting Button
Right of the Fn Button
Enter
Enter Button
2.3 Micro SD, SIM, PSAM Card
Installation
Detailed installation of Micro SD, SIM, PSAM Card steps are as
follows:
2.4 Battery Charging
Use the adapter to charge the battery via the USB connector of the
snap-on. Don't use other brands of charger for device.
TF card
SIM
PSAM

8
2.5 Device Power on/off
Press the ‘Power’ button on the top about 3s due to power on/off. And
press it shortly to wake up.
Chapter 3 Call Function
3.1 Phone
Click this icon .
Click the number button to input the numbers.
Click the button to confirm and dial.
Click the to end the calling.

9
3.2 Contacts
Click ‘Contacts’ to open the contacts list.
Click to add the new contact.
Click to import/export or delete the contact list.
3.3 Messaging
Click to open the message list.
Click to input the content.
Click to send the message.
Click to add photos, videos.
Fav
Conta

10
Chapter 4 Barcode Reader
Open the Barcode Demo in APP Center and then press the ‘Scan’
button to start scanning.
Note: Please scan the barcode correctly, otherwise the scanning might be failed.

11
Chapter 5 RFID Reader
5.1 High Frequency
5.1.1 14443A
Open the 14443A demo within Appcenter, and press the ‘Scan’
button to start reading.
Mifare and Ultralight reading/writing are also supported.

12
5.1.2 14443B
Open the 14443B demo within Appcenter, and gain UID of the card.
5.1.3 15693
Open the “15693” demo within Appcenter, and then reading and
writing information of the tag.

13
5.2 NFC
Open the “NFC” demo within Appcenter, and then reading and writing
information of the tag.
Chapter 6 Other Functions
6.1 PING
1. Open the Ping in Appcenter.
2. Set the Ping parameters and select the
internal/external addresses.

14
6.2 Bluetooth
1. Open the Bluetooth demo in Appcenter and turn on the
Bluetooth.
2. Input the content or select the file, then scan the nearby
Bluetooth printer and pair them.
3. Select the printer and click ‘Print’ to print the content.

15
6.3 GPS
1. Open the GPS demo in Appcenter and turn on GPS
module.
2. Set the GPS parameters and get the GPS data
information.

16
6.4 Volume Settings
1. Open the Volume Setting demo in Appcenter.
2. Set the volumes based on the requirements.

17
6.5 Sensor
1. Open the Sensor demo in Appcenter.
2. Test the sensor based on the requirements.
6.6 Keyboard
1. Open the Keyboard demo in Handset Appcenter.
2. Set and test the key values of the device.
6.7 Network
1. Open the Network demo in Appcenter.
2. Test the WIFI/Mobile signal based on the requirements.

18
Chapter 7 Device Specifications
Physical Parameters
Dimensions
157.6mm*73.7mm*29mm
Weight
297g (includes main battery)
Screen
4in.WVGA (480*800) TFT-LCD, capacitive dual touch
Keyboard
numeric keypad, 3 side buttons
Battery
Main bat. (rechargeable li-ion polymer, 3.7V, 4000 mAh)
Expansion Slot
MicroSD/TF, maximum capacity of 32G
SIM Slot
1 PSAM, 1 SIM, 1 MicroSD
Audio
0.5W wat
Camera
OV 8M pixels, auto focus (optional)
Performance Parameters
CPU
Qualcomm 8909 1.3GHz quad core
OS
Android 5.1
Memory
1GB RAM, Build-in 8GB Flash
Interface
USB Micro-B,
Storage Card Type
TF card
Maximum Expansion
Storage
32GB

19
Environmental Parameters
Operating Temperature
-10℃to 50℃
Storage Temperature
-40℃to 70℃
Humidity
5%RH-95%RH (non-condensing)
Dropping Survive
1.5m/3.9ft. drop, 6 sides, concrete floor under operating temp.
Sealing
IP65, IEC compliance
Wireless Communication
WWAN
EU:
2G: 850/900/1800/1900MHz
3G: 850/900/1900/2100MHz
4G: B1, B3, B5, B7, B8, B20, B40
US:
2G: 850/900/1800/1900MHz
3G: 850/900/1700/1900MHz
4G: B2, B4, B7, B12, B17
CN:
2G: 900/1800MHz
3G: 900/1900/2000/2100MHz
4G: B1, B3, B38, B39, B40, B41
WLAN
IEEE802.11 a/b/g/n, internal antenna
WPAN
Bluetooth v4.0
Table of contents
Other MUNBYN Scanner manuals