Muzio JM-200 User manual

MUZIO (JM-200)
USER MANUAL

MUZIO 2(JM-200) Specs
Category MUZIO Specs
Range of Freguency 20Hz ~ 20KHz
Earphone 1 : (L)12mW + (R)12mW(16Ohm), Volume Max
Earphone Output Earphone 2 : (L)8mW + (R)8mW(16Ohm), Volume Max
Audio
Signal to Noise Ratio 90dB
Frequency Range 76.0MHz ~ 108.0MHz
Earphone 1 : (L)12mW + (R)12mW(16Ohm), Volume Max
Output Earphone 2 : (L)8mW + (R)8mW(16Ohm), Volume Max
FM Radio
Signal to Noise Ratio 50dB
USB Device USB1.1 (Read Speed : 700MB/S, Write Speed : 500MB/S)Removable
Disk USB HOST USB1.1
File Format MPEG 1/2/2.5 Layer 3, WMA, OGG
Bit Rate 8Kbps ~ 384Kbps
File
Support Tag 지원 ID3 Tag V1.0, 2.x
Product Size 84.5mm(width) * 42mm(length) * 23mm(height)
Product Weight Approximately 56g (Including battery)
Operation
Temperature Range -5℃ ~ 50℃
Memory 128MB, 256MB, 512MB,1GB
Play Time Play 15 hours(128Kbps MP3, Vol 20, EQ Normal)
Voice Recording 512MB over 130 hours(8Kbps)
General
Items
Battery Li-Polymer

Power On & Off
1. Press ►/■ button and hold for Power On or Off.
Charging
1. Connect MUZIO into USB Port through USB cable provided or connect into the
power terminal of charger sold separately. When the power is full, Red LED on MUZIO
will be off. (It takes approximately 2 hours)
Basic Operation Function
►/■
Power On/Off or Stop >> In the play mode, select next song
or search next section, and search
next or select next channel in the
FM Mode
-
Interval Repeat Setting,
Play/Radio/Record Mode Change
∧ Speed Control - Speed Up
AVATAR display on/off
●
EQ Change Mode, Start/Stop
Record
∨ Speed Control – Speed Down
AVATAR display On/Off
Rotating
Disk
Volume Up or Down
Turn Right – Volume Up
Turn Left – Volume Down
☼Browsing Mode.
Configuration Mode.
<< In the Play mode, select previous
song or rewind music, and search
previous or select previous
channel in the FM mode.
Hold Hold Switch
Music Listening
Play mode operation
►/■
►/■
Rotate
<<
<<
>>
>>
1.Power ON/OFF : Press and Hold
2.Play/Pause : Short Click
3.Volume Up/Down : Rotate Right/Left
4.Play Previous : Short Push
5.Rewind : Long Push
6.Play Next : Short Push
7.Fast Forward : Long Push

REC
☼
∧ or ∨
8.EQ Change : Short Click after Long Click
9.Folder Change : Short Push
10.Avata Display on/off : Long Push
FM mode operation
►/■
AB
<<or>>
REC
1.FM Mode: At the Power on, select Radio Mode after long press of Mode
Button.
2.STEREO/MONO Change: Short Click
3.Frequency/Preset Change: Short Click
4.Previous or Next Channel Search: Long Push at Frequency mode
5.Auto Scan: Long Click
Voice/Line-in Recording
AB
REC
►/■
1.Record Mode: At the Power on, select Record Mode after long press of
Mode Button.
2.Voice/Line-in Change: Short Click
3.Record Start/Stop: Short Click
4.Record Pause/Continue: Short Click
FM Recording
REC
►/■
1.FM Mode: At the Power on, select Radio mode after long press of Mode
Button.
2.Record Start/Stop: Short Click
3.Record Pause/Continue: Short Click
Play speed control (Study Mode)
∧
∨
1.Set Menu: At the menu setting, select Play -> Play Speed -> on.
2.Speed Up: Short Push
3.Speed Down: Short Push
Menu Setting
1. Press and hold the center of the control. There are six main menus and a lower
menu under the main menu except the exit.
2. Use the <<, >>, ^, | direction to move to the desired menu. After the selection,
Press the center of the control to complete the setting.

3. To return to the main menu, push the control in the << direction.
4.To escape the menu setting, select the exit menu and press it.
Folder Search Function
A user finds and listens to music in a desired folder when listening to music in each
folder.
1. At the play mode, Press the center of the control.
2. Use the <<, >>, ∧, ∨ direction to move to the desired folder.
3. To play, press the center of the control and select the desired file.

USB Host mode operation
1. At the menu setting, select System -> Host/Device -> Host.
2. Connect MUZIO into the external USB Device through mini USB Adapter provided.
3. Pause Play.
4. Select the target file in the external USB device through Folder search function.
5. Press ‘REC’button, then select ‘Copy’.
6. Select the destination of copy at the folder search function, then select ‘Paste’
after pressing ‘REC’button.

FCC Compliance Statements
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates ,uses and can radiate radio frequency energy and ,if not installed and used
in accordance with the instruction , may cause harmful interference to radio communication. However ,
there is no guarantee that interference will not occur in a particular installation.
If this equipment dose harmful interference to radio or television reception, which can be determined by
turning the equipment off and on. The user is encouraged to try to correct the interference by one or more
of the following measures :
-- Reorient or relocate the receiving antenna
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio / TV technician for help.
Warning :
Your are cautioned that any change or modifications to the equipment
not expressly approved
by the party responsible for compliance could void your authority to
operate such equipment.
NOTE : This unit was tested with shielded cables on the peripheral device .
Shieldcablesmustbeused with the unit to insure compliance.