MyLamp Edison Lamp User manual

User's manual
Please read this manual carefully before use.
Edison Lamp - LED Portable Table Lamp
The MyLamp team thanks you for choosing our product.
Please read this manual carefully before use to ensure that
the product is used correctly.
Putting Tab
ON/OFF
100 LUMENS
Polyethylene
USB charging port
Overview

Characteristics
Functions
Operating instructions :
Battery : Rechargeable
Model : Edison Lamp Connection : Type-C USB
Energy : 100 to 240 V
Use only the USB Type-C adapter !
Using a power adapter other than that of the Edison Lamp can
cause irreparable damage and can be dangerous for
the environment. It is best to place the lamp on a dry, horizontal
surface. Avoid exposing the lamp to excessive heat sources.
The Edison Lamp can be used indoors and outdoors without an
adapter. However, protect it from water and store it indoors after
use. Check the voltage of your power source (between 100 and
240 V).
1. Recharge the lamp, using its USB port, by plugging the cable into
a power or computer outlet.
Plug the adapter into the wall socket. It will take approximately
2-3 hours to fully charge the lamp. We recommend recharging
the battery for 8 hours during the first charging.
There is an indicator next to the Type-C USB port.
When the battery is charging, the red light will blink and remain
on when the battery is fully charged.
The battery must always be recharged inside.
Battery : The Edison Lamp contains a battery that cannot
be replaced or disassembled. It must be recycled or disposed of
separately from household waste. For disassembly of the battery
before recycling, contact an official MyLamp dealer.
Elegant, modern, nomadic, simply remarkable. Ideal for a cosy,
subdued atmosphere or for an evening outdoors. Lightweight
and autonomous, you can take it with you anywhere and place
it where you want.
TO BE READ CAREFULLY BEFORE USE !
Loading method

2. Pull the red MyLamp tab to turn on the lamp. The brightness
is adjustable and has three settings :
3. After use, you can turn it off by pulling the red tab.
4. It is possible to clean the lamp with a soft cloth and warm water.
The lamp does not work :
* If the Edison Lamp does not work directly when it is received,
the battery may be empty and you only need to fully recharge
the battery to start using it.
* Please contact our MyLamp customer service if the problem
persists.
* In the event that the lamp no longer operates, the lamp must
be recycled in accordance with local environmental waste
regulations.
* Do not attempt to repair the lamp yourself.
Starting position : the lamp is off
Shoot once : the lamp lights up at the bottom
Shoot a second time : the lamp lights up at the top
Shoot a third time : the lamp lights up completely
Shoot a fourth time: the lamp is switched off again
Comments
Adjusting the intensity Cleaning the Lamp