MYLEC 814 User manual

FRAME H
I
G
E
B
A
C
C
D
D
A
E
BOLT
BOLT
G
37 Commercial Drive, Winchendon, MA 01475 — Phone [phone] — www.mylec.com - Follow us @mylechockey
ASSEMBLY
INSTRUCTIONS
(CONTINUED ON BACK)
ALL PURPOSE STEEL GOAL
ITEM #814
PREPARATION FOR FRAME ASSEMBLY
• Lay out all parts
• Read instructions completely prior to assembly
• Assemble goal on a smooth, flat surface
• Adult supervision recommened for assembly
Prior to assembly, remove black protective tube caps.
x 1Fx 2Ex 2D
x 1Ix 1Hx 2G
x 2Cx 1Bx 2A
TUBING
A. Back and Bottom Crossbars (2)
B. Bottom T-Connector (1)
C. Sidepieces (2)
D. Bottom Front Upright Posts (2)
E. Top Front Upright Posts (2)
F. Top Front Crossbar (1)
G. Back Top Crossbars (2)
H. TopT-Connector (1)
I. Back Support (1)
HARDWARE/TOOLS
2Bolts
1Allen Wrench
NETTING
1Net

ASSEMBLY
Adult Supervision Recommended
WARNING:
Contact sports by their nature pose the continuous threat
of injury which no type of equipment can ensure against or
prevent. All types of Hockey, including Street, Roller, Dek,
Ball, Floor, etc. are dangerous sports. Any person not willing
to assume and be responsible for the risk consequences of
injury should not participate. Equipment may help reduce
the risk of injury, but will NOT prevent it. Participants must
be made aware to stay clear of goals which when contacted
may cause injury.
STEP 1
Lay the net out flat, so the Mylec logo is facing up. Logo area is the top/front of the
net. (See net diagram)
STEP 2
Starting with the bottom of the goal, insert (A) through white nylonback/bottom
sleeve, and connect (A) into bottom T-Connector (B). Repeat with other side sleeve.
Be sure (B) is angled to the front of the goal.
STEP 3
Insert a (C) side piece into the side white sleeve and connect (C) to (A). Repeat with
other side sleeve.
STEP 4
Insert upright post (D) through the front red sleeve and connect (D) to (C). Repeat
with other side sleeve.
STEP 5
Insert upright post (E) through the front red sleeve and connect (E) to (D). Repeat
with other side sleeve.
STEP 6
Insert top crossbar (F) into top sleeve of net (with Mylec logo). Connect (F) to (E).
Repeat with other top sleeve.
STEP 7
Connect both back crossbar tubes (G) into top T-Connector (H) at the center to
create the top shelf of the goal. Be sure (H) is angled to the back of the goal. Connect
the back support (I) to (H). Pass the top shelf into the net and connect back support
(I) into bottom T-Connector (B) to create the back of the goal.
STEP 8
Using the supplied Allen wrench and bolts, attach the back crossbars (G) at the
corners of the top front upright posts (E).
IMPORTANT: Do not assemble the frame separate from the netting, as
the nylon sleeve is connected to all front and bottom edges of the goal.
A piece of tube will slide into each sleeve.
NET DIAGRAM
TOP/FRONT
BOTTOM/BACK