Mytee A600 User manual

A600 Shelving System
Assembly Instructions
This package includes:
Tools required for assembly:
Shelf Supports
(part # P642)
Floor Mount Brackets
(part # H162A)
#14 x 2"Screws
(part # H672)
(actual size shown)
#14 x 1.25"Screws
(part # H671)
(actual size shown)
.25"Flat Washers
(part # H210)
(actual size shown)
#3 Phillips Head Screwdriver
or
Drill with #3 Phillips Head Bit
Cross Bars
(part # H175)
Wall Anchor Brackets
(part # H346)
A B
x6 x12
x2 x2
x24 x16 x40
ADP-A600 REV. 07/30

Assembling the A600 Shelving System
1. Insert four (4) shelving tubes into the four lower slots on
one of the side panels.
3. Place another side panel on the opposite end of the
shelving rods. Make sure each rod is inserted into the
correct slots and screw into place using the 2” A screws
and .25” washers.
Repeat steps 1-3 two more times.
5. Turn the bottom shelf upright and stack the other two
shelves on top of it. Screw each shelf together using the
1.25” B screws and .25” washers.
2. Screw each shelving tube into place using one of the
2” A screws with a .25” washer. Screws should line up
with the pre-drilled holes on the tubes.
4. Take one of the assembled shelves and slide a oor
mount bracket onto the bottom with the ange pointing
outward. Screw into place with the 1.25” B screws and
.25” washers. Do the same on the other side of the shelf.
CAUTION: Do not overtighten.
6. Place the shelving unit in position in the van. The in-
cluded wall anchors can be attached to the top or middle
shelf, on the inside or outside of the supports. Screw
the anchors in place using the 1.25” B screws and .25”
washers. CAUTION: Do not overtighten. Screw the an-
chors and oor brackets into the van. Hardware will vary
depending on the van’s design.
ADP-A600 REV. 07/30
A
AB
BB