NAL RESEARCH CORPORATION SHOUT mcc User manual

SHOUT mcc QUICK START GUIDE Support Phone#: [phone]
[e-mail]
451-22012-002A
2023-03-31
DEVICE DESCRIPTION: The SHOUT mcc is a pocket-sized, low-cost, IP67 rated, handheld satellite tracker and messaging
device. The SHOUT mcc comprises a chassis, touchscreen, a Power/Back button, an LED Status Display, a guarded
Emergency button, a Micro-B USB port, and an Iridium antenna. The touchscreen allows for quick access to menus and ease
of text entry via on-screen soft keyboards. In addition, the M-Code PLI data is streamed to the SHOUT mcc device when
connected to an Army DAPs A-PNT device with a M-Code USB supplied cable.
Rotating
Guard
Emergency
Button
Iridium Antenna
Resistive
Touchscreen
Micro-B
USB
Interface
LED Status
Display
GPS Antenna
(embedded)
Device Status
Power/Back Button
IMPORTANT: The SHOUT mcc must have a clear view of the sky during transmission. 1
DE-15 ConnectorMicro-B USB Connector
M-Code USB Cable

SHOUT mcc QUICK START GUIDE Support Phone#: [phone]
[e-mail]
451-22012-002A
2023-03-31
DEVICE STATUS BAR: Device status bar displays status symbols along the top three lines of all screens.
Some symbols do not appear until an event is initiated, such as sending or receiving a message.
Iridium Signal
One or more messages are in the Outbox ready to be
sent or one or more messages in queue failed to send
Tracking on when the symbol is bright white. The
symbol turns dimmed gray when tracking is off
Mailbox Check is on when the symbol is bright white. The
symbol turns dimmed gray when Mbox Check is off. It is only
available when the Iridium link is enabled. It checks for any
pending messages at the Iridium Gateway.
Geofences:
On -symbol is bright white
Off -symbol is dimmed
One or more unread messages are in the Inbox
Audio alert is on
Battery Indicator: battery is being charged
M-Code Signal
Date
Call Out is on when the symbol is
bright white. The symbol turns
dimmed gray when Call Out is off.
2
Time till the next tracking report transmits.
Time

SHOUT mcc QUICK START GUIDE Support Phone#: [phone]
[e-mail]
451-22012-002A
2023-03-31
911 EMERGENCY
Activate 911 Emergency: Press the 911 Emergency button on the device.
The Status bar turns red and the status LED turns solid green.
An alert is immediately sent to a designated monitoring center(s).
Cancel 911 Emergency: Navigate to the Tracking Menu and select Cancel 911 .
NOTE: The Cancellation message is queued in the Outbox to be transmitted, and the
Emergency mode ends immediately. Turning the SHOUT mcc off does not cancel the
Emergency mode. You MUST select the Cancel 911 option to cancel the emergency.
3
POWER ON/OFF DEVICE
Press the Power button for two seconds to turn on device.
Press the Power button for two seconds to turn off device.
oA Warning message displays. Press Turn Off.
oThe Power Down or Lock screen displays
oPress Turn Off, Lock, or Cancel
oUnplug the M-Code USB cable while powered off to allow the
SHOUT mcc to conserve power.
Power Button

SHOUT mcc QUICK START GUIDE Support Phone#: [phone]
[e-mail]
451-22012-002A
2023-03-31
4
CONNECT M-CODE DEVICE
1. Power on the SHOUT mcc.
2. Power on the DAPs device.
This device contains the M-Code receiver.
IMPORTANT: Devices must be powered on, prior to
connecting serial cable to devices. If not, battery life is
shortened.
3. Connect the DE-15 connector on the M-Code USB cable to the DE-15 connector port on the DAPS device, and
connect the Micro-B USB connector on the M-Code USB cable to the Micro-B USB connector port on the SHOUT mcc
device. “M-Code” displays in the Device Status Bar.
IMPORTANT: If the M-Code USB cable disconnects from either device, the SHOUT mcc will not receive M-Code PLI
data and will revert to the commercial GPS for PLI data.
MESSAGES
Check Messages
1. Select Texting from the Home screen.
2. Select Inbox from the Texting screen.
•Read messages have a white opened envelope symbol next to them.
•Unread messages have a green closed envelope symbol.
•A closed envelope symbol appears at the top of the screen when an unread message(s) is in the Inbox.

SHOUT mcc QUICK START GUIDE Support Phone#: [phone]
[e-mail]
451-22012-002A
2023-03-31
Compose Message
1. Select Texting from the Home screen.
2. Select Compose from the Texting screen.
NOTE: From the Compose menu, you can enter, edit free text messages, and send
canned messages, or a combination of canned and free-text messages to: a NOC
server, a predefined list of email addresses, and/or any email addresses entered
via the keyboards.
Sent Messages
1. Select Texting from the Home screen, then select Sent from the Texting
screen . This displays a list of messages that were successfully sent to the NOC. A
message can be resent, forwarded, or deleted.
5
CHARGING BATTERY
Fully charge the SHOUT mcc before use. The SHOUT mcc must be kept in
environments between 0°C (32°F) and 45°C (113°F) when charging.
The SHOUT mcc can be charged with an AC wall adapter or connect to a standard
USB device.
NOTE: the battery symbol turns red when the remaining power is less than 20%.
A warning message appears when the remaining power is less than 10%.