Nameek's New Space Series User manual

x2
x2
x2 Nuts
Insulation
Sleeve
Hanger
Bolts
(8mm)
Washer
x8 Expansion
Anchor
Bolts
x2
x1
x4
x8
x2 Wall Anchor
x2
1
Included Sink Installation Hardware
Vanity Installation Hardware
Tools You May Need
Following these mounting instructions with the hardware included will be more than
sufficient to support vanity installation.
Level Tape
Measure
Drill
Hammer
Phillips
Screwdriver
Caulk
Mounting
Bracket
Bottom
Mounting
Bracket
Handle
Screw
Installation Instructions
New Space Collection

1. Prepare Location
Locate studs in the wall. If the
studs do not line up with the
holes in the back of the sink and
vanity, be sure to add sufficient
wall supports behind the finished
wall.
2. Mount Vanity
Brackets
Mark the desired height of the
vanity on the wall. Mark the
location of the mounting brackets
and bottom of the vanity. Drill pilot
holes and install the three (3)
mounting brackets. Check position
with a level.
2
3 x
3 x
2 x

3. Install Vanity
Base
Hang vanity base on mounting
brackets. Use a phillips head
screwdriver for adjustments
and tightening.
4. Attach Vanity
Handles
Use a phillips head screwdriver
to attach handles to vanity doors
and drawers.

x2
x2
x2
x2
5. Install Hanger
Bolts
Measure the distance between mounting
holes in the back of the sink. Drill pilot
holes and screw in hanger bolts. Check
the position with a level.
6. Mount Sink With
Washers and Nuts
Thread the sink on to the two
hanger bolts. Secure the sink
with insulation sleeves, washers
and nuts. Be careful not to over
tighten the bolts. Over tightening
can cause the sink to chip and
crack.
3

Click-Clack
Drain
Faucet
8. Vanity Accessories
Complete your installation by
adding the preferred plumbing
accessories, such as the faucet,
click clack drain, p-trap and
angle valves to your vanity.
7. Install Caulk
Finish the sink installation with
a bead of caulk between the sink
and wall.
4