Current as of 2019-04-23
16324
Nauticam Cinema System Gear Set
for Micro-Nikkor 70-180
Instruction Manual
O EWO D
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recogni e the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Please read this manual carefully before using the product, this will maximi e
its performance as well as its lifetime.
A ANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use.
This warranty only applies to products purchased from authori ed
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authori ed
service centre(s). Please note that this warranty only applies when the product
is purchased in the territory where the service centre is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthori ed modifications and/or repairs of our products will automatically
invalidate the warranty.
DENTIFICATION OF
A TS
HOW TO DISTINGUISH FOCUS AND ZOOM
INGS
The oom C-ring is longer than focus C-ring.
OUNTING THE
EA ON A LENS
1. Insert the oom c-ring as shown and place it over the lens.
Make sure the flange of the c-ring upwards
2. Insert the Nikkor 70-180 oom gear on the oom c-ring until it
reaches the flange of the oom c-ring.
3. Insert the focus c-ring as shown and place it over the lens
Make sure the flange of the c-ring downwards
Spare Rubber grips for Support ring
<Focus C-ring> <Zoom C-ring>
