9
WIFI 1080P FHD
INSERTING THE MICRO SD CARD
Carefully push the memory card into the card slot,as shown in the diagram below (using yourfingernail).The
MicroSD card will “click into place”.To take the memory card out,gently press the end of the memory card
inward using your fingernailuntil a click is heard.An internal spring will then release the card.
Note: This camera has no built-in memory.A memory card is needed for operation.
Note 2: High Definition and High Frame Rate video capture devices, place huge demands
on memory cards. Pending your user settings, it is recommended that a CLASS 10 SD
Card be used to avoid Read/Write complications, which willappear as an error message
on the screen during use.If you are not sure, please testany lower class cards
(Read/Write speed) in the device before use.
START-UP/SHUTDOWN
START-UP: Press and hold the power button until the Digital readout displays“ON”
Note: The remote control cannot turn the camera ON. You must use the power button
on the camera
SHUTDOWN:Pressand hold the power button until the Digital readout displays “OFF”.
Note 1: The camera will automatically shut down after 5 minutes of inactive use to conserve power.
Note 2: If thereis notenough power the low power battery icon will flash. When power has been exhausted
the camera will shutdown.
Note 3: The camera can be turned off with the remote control.
START RECORDING / TAKE PHOTO
When the camera is turned on, itwill automatically enter video mode. Either select another modeor start
recording video by simply pressing the shutter button
Note: To stop video recording, press the shutter button again.When the memory card is full or the battery is
too low, the camera willalso automatically stop recording.
CONNECTING TO A COMPUTER
Files can be played back directly from the Camera to a Windows ® Computer via a USB cable.The camera will
appearas a common removable disk under Window Explorer. (Drivers are not required)
