NCR 7409-K361 Manual

7409‐K361
FixedAngleMountMSRand
ImagingScanner
KitInstructions
IssueA

Revision Record
Issue Date Remarks
A Sept 2012 First Issue

1
Introduction
ThiskitprovidesaDIPMSRandN5680ImagingScannerassemblyfortheNCR
SelfServ60(7409).Theassemblyinstallsonthefrontofthe7409‐K035FixedAngle
Mount.
Components
31476
Screw, 6-32 x 0.312, PH, Ph
006-8616637
N5680 Imager
497-0476023
Fixed Angle Imager Bracket
497-0476543
Sankyo NX DIP Reader
497-0472897
DIP MSR Mounting Bracket
497-0475552
Nut, 6-32 KEP
006-8611426
Screw, 6-32 x 0.250,PH, Phil
006-8611016
FixedAngle Mount Mobile Base
497-0465548
FixedAngle Mount Faceplate
497-0476554
Screw, 4-40 x 0.5”, PHil
006-8611154
DIP MSR Insulator
497-0465553

2
Installation Procedures
1. Removethescrews(2)inthesidesoftheFixedAngleMount.
2. RestthebottomofthedisplayontheDisplaySupport.
Note: PlacetheDisplaySupportbehindtheextensiononthenDisplayHinge
Bracket.
31462
Screw
(One each side)
31469
Display Support

3
3. RemovetheterminalCableCover(1captivescrew).
4. RemovetheBlankFaceplatefromtheFixedAngleMount(2screws).
31468
Cable Cover
31464
Blank Faceplate

4
5. ConnectthecablestotheimagerandMSRdevices.
6. InstalltheFixedAngleMountFaceplateonthefrontoftheFixedAngleMount
(2 screws).
31471
MSR RS-232 Power
MSR USB Data
Imager USB
31479

5
7. ConnecttheUSBcabletotheterminalI/OPanel.
8. LowertheDisplaybacktotheoperatingpositionontheFixedAngleMountand
secureitwithscrews(2).
27661a
USB Ports
Terminal Power RS-232 Ports
31462
Screw
(One each side)

6