Neets SB1 User manual

50 mm 750 mm
Center Line
50 mm
1:1 Neets Sound Bar - SB1 Drilling Template
See other side for
Installation Guide

Installation Guide
Neets Sound Bar - SB1™
Mounting
Wall
Use the drilling template on the back
side of the installation guide to mark
the correct position of the brackets.
See other side for
Drilling Template
Connecting
Auto On/Off
Position the slide switch in the con-
nector panel on the back side of the
Sound Bar to "Auto On/Off". Then
connect input and power cables.
RS-232
Position the slide switch in the con-
nector panel on the back side of the
Sound Bar to "RS-232". Then connect
input and power cables.
For further details on configuration of
RS-232 see manual at neets.dk
http://www.neets.dk/products/sound-bars/166#Resources
Connector Panel
Table
Mount the four rubber feet at each
corner of the bottom of the Sound
Bar. Place the Sound Bar on any even
surface.
Mount the brackets onto the wall.
Then screw the four thumb screws
included in the box into the Sound Bar.
See drawing for correct placement.
Place the Sound Bar on the brackets
and adjust the two thumb screws
(marked on the drawing) for correct
spacing to the wall. Thumb scews
for adjustment
OPTICALIN
RS-232
G
Tx
Rx
L– L+ R+ R– G
UNBALANCEDBALANCED
L R
DC INPUT
AUTO
ON/OFF
RS-232
1 2