Net World Sports Fortress User manual

www.networldsports.co.uk // [phone] // [e-mail]
www.networldsports.com // 1-866-861-9095 // [e-mail]
@NetWorldSports
Pop up Batting Cage

PARTS LIST
PART COMPONENT QTY
3 Sets
of poles
1 net
8 guy
lines
1 set of
pegs
1
2
3
4
Please check all components are present
and have no defects.
Please read through the instructions carefully
before assembly.
Never climb or swing on the poles or net.
This product is not a toy, serious injury can occur
if the product or it’s components are misused.
Step 1 Layout and check all components are correct.
Unfold net ensuring pole sleeves are on the outside.
Pole sleeves
5
1 end
Panel

Step 2
Tie guy lines to Pole sleeves
Tie 6 guy lines to the loops on the pole sleeves
If required, 2 extra guy lines can be added to the ends of the cage
Extra guy lines
Step 3 Assemble the fibreglass poles and thread one through each
of the pole sleeves..

Once the poles have been threaded through the sleeves locate the pins
that are attached to the net into the holes at the end of the poles.
Step 4 Ensure cage is straight and in the desired position then hook guy lines
to the pegs and tap pegs into the ground. Once pegs are in place tension
the guy lines.
Tap in remaining pegs through the loops at the bottom of the centre
pole sleeves

Step 5 Once the cage is fixed to the ground, if required attach the end panel
using the toggles around the frame of the net to fully enclose the cage.
Additional steps.
It is possible to remove the centre floor strap to avoid bowling or pitching on to it.
Simply unclip the strap from the frame on each side.
If you have a pitching machine you can set this up to pitch through the hole in the
detachable end panel of the cage.
If you have purchased 2 cages to make a fully enclosed cage simply follow steps
1 to 3 for assembling the cage then move the two open ends of the cages together
and connect using bungee ties supplied. Once this is complete continue with step 4.
See the below diagram.