200Mbps Powerline
Adapters with
AC Pass-through
The NetComm 200Mbps Powerline Adapters with AC Pass-through allow you to create an Internet
connection point anywhere in your house using the existing network of power lines. The Internet
signal is transferred between the two pre-paired adapters – all you have to do is connect them to
an available power point.
With more devices becoming Internet enabled, there is a need for connections in various rooms
of the house. The NP207 provides an easy way to transfer the Internet from your modem and
supplies fast and reliable Internet access to your chosen device.
With built in AC pass-through, you are able to use the same power point to plug in other electrical
appliances. This allows you to connect the powerline adapter directly to the wall, guaranteeing
the best possible signal and reduces the likelihood of needing to use powerboards and double
adapters.TheNP207alsofeaturesbuilt-inlteringtoreducenoiseintroducedbyotherelectrical
devices around the home to improve the network performance over the power lines.
The NP207 features a very compact form factor and is unobtrusive and easy to conceal behind
furniture and home entertainment units.
EnhancedQualityofService(QOS)providesguaranteedbandwidthreservationsforspecic
multimedia IP streams.
1 Maximum throughput based on theoretical data rate. Actual data throughput will vary. Network conditions and environmental
factors,includingvolumeofnetworktrafc,andnetworkoverhead,loweractualthroughputrate.
SPECIFICATIONS
MAIN CHIPSET
• QCA6 410
STANDARDS
• Powerline: HomePlug AV
• Ethernet: IEEE802.3 10/100 Ethernet
• Compliant to EuP Lot requirements
(Power saving standard)
MODULATION SUPPORT
• Powerline: OFDM 4098/1024/256/64/16/8 QAM
• QPSK
• BPSK
• ROBO
DATA TRANSFER RATE
• Up to 200Mbps over Powerline
RANGE
• Up to 200m over Powerline
SECURITY
• 128-bit AES Encryption (enabled with Simple Connect
button)
POWERLINE FILTERING
• Filtering at frequency band 2MHz to 30MHz
PHYSICAL SPECIFICATION LED INDICATORS
• 1 x Power LED
• 1 x Powerline Link / ACT Status LED
• 1 x Ethernet Link / ACT Status LED
EXTERNAL CONNECTORS
• 1 x Ethernet LAN port
• 1 x Reset button
• 1 x Simple Connect push button
• 1 x Filtered AC pass-through
MEASUREMENTS
• 116mm x 62mm x 42mm
• 200g / adapter
MEMORY
• 2MB SPI Flash
POWER CONSUMPTION
• Normal: 2 Watts (230 VAC)
POWER SUPPLY
• Switch mode 100 ~ 240V
ENVIRONMENTAL TEMPERATURE
• Operating: 0°C to 40°C
• Non-Operating: -25°C to 70°C
HUMIDITY
• Operating: 30% to 80% relative humidity
(non-condensing)
• Non-Operating: 30% to 95% relative humidity
(non-condensing)
OPERATING SYSTEMS
(FOR MANUAL CONFIGURATION ONLY)
• Windows 7/Vista (32-64 bit)/2000/ME/XP/98/98SE
REGULATORY APPROVAL
• SAA101230EA
• RCM
Study Bedroom Kitchen Loungeroom