NetNearU RAP-1 User manual

NetNearU
RAP-1
Wireless Made Easy
Revision 1.1

Federal Communication Commission Interference Statement
WARNING: This equipment has been tested and found to comply with the limits
for a class A digital device pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction’s manual, may cause interference to radio
communications. Operation of this equipment in a residential area is likely to cause
interference in which case the user will be required to correct the interference at his
own expense.
The user is cautioned that changes and modifications made to the equipment without
the approval of manufacturer could void the user’s authority to operate this
equipment.
Responsible Party: NetNearU
2908 Finfeather Road
Bryan, TX 77801
Telephone No. – [phone]
Fax No. – [phone]
Warning to ALL users:
In order to comply with the FCC RF exposure limits, it is recommended, that the
device’s antennas should not be positioned closer than 20cm from your body or
nearby persons for extended period of time while it is transmitting (or operating).
Quick Start Guide
Your wireless/remote access points will include the following hardware.
Make sure you have everything you need before proceeding.
1. RAP1 device itself
2. AC to 5 Volt DC switching mode power supply
3. RJ45 Ethernet cable
Figure 1
1. Gently rotate the antennas such that they are pointing upward and form a
“V” shape.
2. Connect the supplied power supply to the wall, and the power port to the
unit itself. (figure1 #3)
3. Connect one end of the supplied network cable to the Internet connection
device or port, and the other to the 10BaseT WAN port on the wireless
device. (figure1 #1)
**NOTE: DHCP service must be running on the network in order for the
unit to operate in default mode. If this device is to be installed in a fixed IP
address environment, please call NetNearU Customer Service at 888-412-
8324 for configuration assistance.
4. Flip the power switch to the “on” position to start unit. The unit takes
about 90 seconds to initialize before ready for usage. (figure1 #2)

Technical Specification
Processor: System on Chip Embedded Processor, Pentium Class running at 100MHz
Memory: 64MB of SDRAM as main memory, 16MB of Flash as system storage device
Wireless Standards: IEEE 802.11b
Frequency Band: 2.400GHz to 2.4835GHz (depending on local regulation)
Transmission Method: DSSS (Direct Sequence Spread Spectrum)
Data Rate: 11Mbps, 5.5Mbps, 2Mbps, 1Mbps
Modulation: 11Mbps and 5.5Mbps CCK; 2Mbps: DQPSK; 1Mbps: DBPSK
Output Power: TYP. +14dBm
Operating Range: 100 feet to 300 feet indoor
WAN Port Input: 10-Base-T Ethernet (IEEE 802.3), with DHCP or Fixed IP
Addressing
LAN Output: (Future Option) to connect additional Wireless Access Point.
Operating Temperature: 0 to 45 degrees Celsius, 0-90% Relative Humidity, Non-
Condensing
Unit Weight: 2.3 lbs (with 5V DC power adaptor)
Power Requirement: UL approved 5V DC power source as provided, 120V AC
Input
Due to continuous improvement, specification is subject to change without notice.