•To boil water, put the kettle onto the power base, press the
100°C button and the kettle will start heating the water up. At
this time, the indictors on the control panel do not light up but
the indicator light inside the kettle will illuminate red. When
the water reaches 100°C, the indicator light will turn off and
two beeps can be heard.
•To heat water to a selected temperature, put the kettle on the
power base and press the +/- button to select your desired
water temperature. Once selected, the corresponding
indicator light will turn on. Press the 100°C/power button and
the kettle will start to heat the water up. Once it reaches
temperature, all light indicators turn off and two beeps can be
heard.
•To keep water warm, put the kettle onto the power base and
press the +/- button to select your desired keep-warm
temperature. After selecting the temperature, the
corresponding indicator light will turn on and then you need to
press and hold the 100°C/power button for 3 seconds.
•The kettle will enter a keep-warm mode after heating the
water to the selected temperature. At this time, the indicator
light of the selected keep-warm temperature will blink in one
second intervals. Once the water temperature reaches the
desired temperature, one beep can be heard and then the
kettle will enter the keep-warm function. After keeping warm
for 30 minutes, the kettle will shut off automatically and all the
indicator lights will turn off.
•Lift the kettle from the power base and pour the water. The
water will not re-boil until the switch is pressed again. The
kettle may be stored on the power base when not in use.
