IMPORTANT SAFETY INSTRUCTIONS:
•Read all instructions before using.
•Before connecting the kettle to the power supply, check that the voltage
indicated on the appliance (underside the kettle and base) corresponds with
the voltage in your home. If this is not the case, do not use the kettle.
•The attached base can not be used for other than intended use.
•Do not operate the appliance without load to avoid damaging the heat
elements.
•Unplug from the outlet when not in use.
•Do not let the cord hang over the edge of a table or counter OR let it touch
hot surfaces.
•Do not place on or near a hot gas or electric burner or in a heated oven.
•Should you accidently allow the kettle to operate without water, the boil-dry
protection will automatically switch it off. If this should occur, allow the
kettle to cool before filling with cold water and re-boiling.
•Ensure that the kettle is used on a firm and flat surface where children can’t
touch.
•To protect against fire, electric shock or personal injury, do not immerse the
cord, electric plugs or kettle into water or other liquids.
•Always take care to pour boiling water slowly and carefully without tipping
the kettle too fast.
•Be careful when opening the lid for refilling when the kettle is hot.
•Close supervision is necessary when any appliance is used by or near
children.
•Do not touch the hot surface. Use the handle or the button.
•Extreme caution must be used when moving an appliance containing hot
water.
•The appliance is not a toy. Do not let children play with it.
•The use of attachments that are not recommended by the appliance
manufacturer may result in fire, electric shock or personal injury.
•While boiling water, avoid making contact with steam from the spout when
water is boiling or just after it has switched off.
•Unplug from outlet when not in use and before cleaning.
•Always ensure the lid is closed and do not lift whilst the water is boiling.
Scalding may occur if the lid is removed during the brewing cycles.
•If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or a similar qualified person in order to avoid hazard.
