NEXELO RUBY L188015NEX User manual

L188015NEX
PL Instrukcja obsługi
GB User manual

Instrukcja obsługi
www.nexelo.eu
PL Dziękujemy za wybranie naszego produktu. Przed użyciem przeczytaj instrukcję obsługi.
INFORMACJE OGÓLNE:
5 diod SMD LED.
10 lumenów.
4 funkcyjna.
Obudowa: plastik.
Wodoodporność: IPX 4.
LAMPA AKUMULATOROWA TYLNA NEXELO – RUBY L188015NEX
ZASILANIE:
Akumulator LiPo 200 mAH.
Ładowanie przewodem micro USB.
Czas ładowania: 0,5 – 1 godzina (w zależności od ładowarki).
CZAS PRACY:
Tryb wysoki – 3 godziny.
Tryb średni – 15 godzin.
Tryb migający – 6 godzin.
Tryb migający średni – 8 godzin.
MONTAŻ:
Umieścić uchwyt w obudowie lampy i za pomocą paska zamontować na sztycy siodełka.
OBSŁUGA:
Wskaźnik ładowania: czerwona dioda LED włączona.
Wskaźnik naładowania: czerwona dioda LED wyłączona.
Aby włączyć/wyłączyć przytrzymaj przycisk przez 1,5 sekundy.
Kliknij przycisk aby zmienić tryb.

www.nexelo.eu
Instrukcja obsługi
Akumulator jest na stałe wbudowany do urządzenia i nie można go wymieniać. Należy regularnie
ładować akumulator. Jeśli urządzenie nie będzie używane przez dłuższy czas, należy je
przechowywać w stanie pełnego naładowania. Zaleca się, aby raz w miesiącu całkowicie naładować
i rozładować urządzenie.
Stosowanie się do zaleceń zapewni optymalną wydajność akumulatora. Nie wystawiać na działanie
wysokiej temperatury. Silne wstrząsy, uderzenia lub upuszczenie produktu mogą spowodować jego
uszkodzenie.
Nagrzewanie się urządzenia podczas ładowania jest normalnym zjawiskiem. Nigdy nie pozostawiaj
ładującego się urządzenia bez nadzoru, aby zawsze być w stanie zareagować w przypadku
wystąpienia potencjalnego problemu. Zabronione jest podłączanie do ładowarki na całą noc!
Podczas ładowania lampkę można pozostawić włączoną w trybie słabego światła. Przedłuży to czas
uzupełniania poziomu naładowania akumulatora, ale pomoże to zabezpieczyć urządzenie przed
dalszym doładowywaniem w momencie osiągnięcia pełnego naładowania akumulatora (poziom
będzie spadał, gdy lampka pozostanie włączona).
Należy unikać przedłużonego ładowania, gdyż przeładowanie ogniwa prowadzi do zainicjowania
w jego wnętrzu nieodwracalnych reakcji, których następstwem jest podwyższenie temperatury, co
może skutkować pożarem.
Przed wyjściem z pomieszczenia należy odłączyć urządzenie od źródła zasilania. Na czas
ładowania połóż produkt na powierzchni niepalnej i odpornej na ciepło. Zaleca się używania
oryginalnego przewodu do ładowania urządzenia. Po naładowaniu do pełna odłącz kabel zasilający.
Uszkodzenie mechaniczne powłoki akumulatora lub niewłaściwe ładowanie akumulatora może
spowodować wybuch i pożar!
W przypadku stwierdzenia jakichkolwiek nieprawidłowości podczas ładowania należy natychmiast
odłączyć lampkę od źródła zasilania.
W celu uniknięcia prawdopodobieństwa porażenia prądem należy najpierw odłączyć od zasilania
ładowarkę. Nie należy rozkręcać urządzenia, ani dokonywać napraw we własnym zakresie, gdyż
może to prowadzić do trwałego uszkodzenia lampki i naruszenia warunków gwarancji. Jeżeli lampka
miga lub świeci nieregularnie, może to być związane z niskim poziomem baterii. Należy naładować
akumulator, a jeśli mimo tego sytuacja się powtarza, należy skontaktować się z autoryzowanym
dystrybutorem.
Ostrzeżenie:
Lampka jest urządzeniem emitującym światło o dużym natężeniu, które może spowodować
poważne uszkodzenia wzroku użytkownika lub osób trzecich.

User manual
www.nexelo.eu
GB
GENERAL INFORMATION:
5 SMD LEDS.
10 lumens.
4 functions.
Plastic case.
Waterproof design IPX 4.
NEXELO REAR RECHARGEABLE BATTERY LAMP – RUBY L188015NEX
USAGE:
Charging indicator: red LED on.
Charge indicator: red LED off.
To turn on / off, hold the button for 1,5 seconds.
Click the button to change the mode.
POWER SOURCE:
Battery LiPo 200 mAh.
Charged by the micro USB cable.
Full charge time: 0,5 – 1 hour (depends on charger).
LIGHTING TIME:
High mode – 3 hours.
Medium mode – 15 hours.
Flashing mode – 6 hours.
Medium flashing mode – 8 hours.
INSTALLATION:
Install the holder in the lamp body and attach it to the seat post with the strap.
Thank You for choosing our product. Please read user manual before use.

The battery is permanently built into the device and cannot be replaced. Charge the battery regularly.
If the device is not used for a long time, keep it fully charged. It is recommended to fully charge and
discharge the device once a month.
Following above recommendations will ensure optimal battery performance. Do not expose to high
temperatures. Strong shocks, impacts, or dropping down the product may damage it.
It is normal for the device to get warm while charging. Never leave the device during charging
unattended to be able always to react in case of a potential problem. It is forbidden to connect to the
charger for the whole night!
The lamp can be left on in low light mode while charging. This will extend the time of filling the
recharging battery level, but it will help to protect the device from further recharging once the battery
is fully charged (the level will drop down while the light stays switched on).
Prolonged charging of the device should be avoided, as overcharging of the cell leads to the initiation
of irreversible reactions inside it, which can result in temperature increase, which may cause the fire.
Disconnect the device from the power source before leaving the room. Place the product
on a non-flammable and heat-resistant surface when charging. It is recommended to use the original
cable to charge the device. When fully charged, unplug the power cable.
Mechanical damage of the battery body or improper charging of the battery may cause an explosion
and fire!
If you find any irregularities during charging, immediately disconnect the lamp from the power
source.
To avoid the possibility of electric shock, disconnect the charger first. Do not disassemble the device
or make repairs on your own, as this may lead to permanent damage to the lamp and violation of the
warranty. If the light flashes, it may be caused by low battery level. Charge the battery, and if the
situation persists, contact an authorized distributor.
Warning:
The lamp is a device that emits high-intensity light that can cause serious eye damage to the user or
third parties.
User manual
www.nexelo.eu
Table of contents
Languages:
Other NEXELO Outdoor Light manuals
Popular Outdoor Light manuals by other brands

Reliance Foundry
Reliance Foundry Concrete Bollard Installation

Dale Tiffany
Dale Tiffany TA100353 Assembly instructions

VIBIA
VIBIA Class 2820 Assembly instructions

Quoizel
Quoizel SFD8407IB Assembly instruction sheet

SMARTPOINT
SMARTPOINT SPSDISCLT user manual

EASY LED
EASY LED PRO Flow L Cleaning and maintenance