Home Zone Security ELJ9542V User manual

[phone]
IMPORTANT SAFETY OPERATING INSTRUCTIONS
1. Please read all warning and instruction labels which are included in the box and fixture to avoid personal injury, property damage
caused by fire, cuts, bruises, death and other dangers.
2. Please follow these general precautions before installing, maintaining, or fixing
1. It is important to select an outdoor location with full, direct sunlight where the solar panel can receive at least 8 hours of sunlight
each day.
2. It is important to avoid placing the solar light by light sources, such as street lights or porch lights, which may cause the solar light
to turn off automatically.
3. To avoid explosion and corrosion, please keep the solar light away from from fire and humid environment
4. No striking to avoid any damages to solar cell
1. The packing contains small parts that could be swallowed by children
2. Keep the packaging material away from children and pets
3. The solar light is not a toy
4. We do not take responsibility if the instruction manual is not followed correctly or if the product is handled
improperly resulting in damage to person or property
PRECAUTION
REF. PARTS
1. Dimension: approx. W.3.27"(8.3cm) x H.5.12"(13cm) x D. 1.38" (3.5cm)
2. Light source: 3pcs white LEDs
3. Brightness: 5lumens for standby; 40lumens for motion sensor activated
PARAMETER
Solar Unit 1pc screws and 1pc plastic anchor
Solar Powered Motion Sensor
Wall Light (2-Pack)
Model No. ELJ9542V

[phone]
Figure 1
- Slide the switch to "AUTO" position
Figure 2
1. Choose desired wall location. Drill one hole on the wall. Insert the plastic anchor and screw the screw into the wall, leaving 2mm
long thread.
2. Hang the light on the screws with the mounting hole
Note: Lights with crystalline panels may have a protective film over the solar panel. This must be removed prior to use.
1. Use a damp cloth to clean the solar panel
2. To avoid any damage to this light, please do not use any chemical or abrasive cleaner
HOW TO OPERATE AND INSTALL
HOW IT WORKS
CLEANING AND MAINTENANCE
Solar Powered Motion Sensor
Wall Light (2-Pack)
Model No. ELJ9542V
Figure 1 Figure 2
This product contains (1) 3.7V 14500 400mAH Li-ion rechargeable battery. When
the battery expires, it must be recycled or disposed of properly. Please contact
your local waste disposal authority for correct procedure. Do not put battery into
fire.
1. Use a screwdriver to remove the 4 screws on the back of the unit.
2. Open the battery chamber cover.
3. Replace the old battery with new battery making sure the polarity is correct.
4. Place back the battery chamber cover by tightening the 4 screws.
Battery replacement
RECHARGEABLE BATTERY
Solar panel collects
sunlight to charge
the battery (included)
during the day
Automatically turns
on at dusk for up to
8 hours of nighttime
illumination
1 2
Solar panel collects
sunlight to charge
the battery (included)
during the day
Automatically turns
on at dusk for up to
8 hours of nighttime
illumination
3 4
a