WE-EF PIA230 LED User manual

WE-EF LEUCHTEN
Installation and
Maintenance Instructions for
Facade & Ceiling Washlight
PIA230 LED
PIA240 LED
INSTALLER
HOTLINE
[phone]
7am – 7pm AEST

1
Facade and Ceiling Washlight
148 ø 180
ø 13
ø 6.5
15
140
410 210
Ø 5.5 - 12 mm
2,5 mm2
Mounting options
Lamps
PIA230 12 LED 24W / 18 LED 36W*
PIA240 18 LED 54W / 1050 mA*
24 LED 72W / 1050 mA*
* Nominal power, for latest data refer to www.we-ef.com
Protection: IP66 / IK08
Class I, II, ta = 25°C
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10,5 kg
Mounting height . . . . . . . . . . . . . . . . . . . . . . . . . . 2,5–4,0 m
Windage area . . . . . . . . . . . . . . . . . . . . . . . . . max. 0,103 m²
560 210
195 140
ø 20
ø 13
ø 180
PIA230
PIA240
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12,5 kg
Mounting height . . . . . . . . . . . . . . . . . . . . . . . . . 4,5–6,0 m
Windage area . . . . . . . . . . . . . . . . . . . . . . . . . . max 0,15 m2
PIA230
PIA240

2
Installation
The product must be installed and maintained by a suitably
qualified professional in compliance with latest building/
construction and/or electrical regulations and relevant
legislation.
Warning: Switch off and isolate the mains electrical
supply prior to installing and connecting the luminaire. Do
not open luminaire while mains supply is switched on.
Notice: If the luminaire is modified by anybody other than
the original manufacturer, then the warranty will no longer
be valid and shall become the full responsibility of the
modifying person/organisation. Claims based on defects
attributable to improper installation and/or application, and
the consequences thereof, are excluded.
In case of component failure, LED replacement due to
abnormal circumstances or at end of life, replacement must
be carried out by a suitably qualified and trained professional.
In case of questions please contact our technical hotline:
[phone] (from Monday -Friday from 07.00 until
19.00 hours.
Maintenance
Apart from cleaning the product’s exterior surfaces, no
special maintenance work is required. Do not use high-
pressure cleaners.
Protect our environment: Discard used LEDs in compliance
with the most recent environmental legislation.
Notice: In case the luminaire is equipped with an optional
available surge protector, the function can get tested if the
signal LED is lit green when the supply voltage is turned on.
In case the surge protector is defective, the LED device
gets automatically disconnected from the mains supply. If
the signal LED is not lit, the luminaire is not functioning.
Installation Procedure
1) Switch off and isolate the mains electrical supply.
2) Loosen screws A and remove luminaire B.
3) Install the fixing plate D at the assigned position and
firmly tighten cable gland C. Use a fixing element suitable
for the material of the installation (not in scope of supply).
4) Place luminaire B on the fixing plate D and firmly tighten
screws A.
5) Ensure the supply is suitable for the luminaire type.
Connect the flexible lead to the supply, the cable is
labeled with the connection data.
6) The luminaire can be adjusted to an inclination + 30°by
loosening ofthe screw E, positioning and re-tightening.
C
6,5
15
A
B
D
E
C

PIA230_240_LED_010416 / 006-1326
Technical specifications are subject to change.
© WE-EF 2018
WE-EF LIGHTING
Thailand
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
Australia
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
United States of America
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LEUCHTEN
Germany
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LUMIERE
France
Tel [phone]
Fax [phone]
[e-mail]
WE-EF HELVETICA
Switzerland
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
United Kingdom
Tel [phone]
Fax [phone]
[e-mail]
www.we-ef.com
Safety indices
The manufacturer is then discharged from liability when damage is
caused by improper use or installation.
If any luminaire and/or accessory is subsequently modified, the
persons responsible for the modification shall be considered as
manufacturer.
INSTALLER
HOTLINE
[phone]
7am – 7pm AEST