Quick Installation Guide
Copyright © NRadio Technologies Co.,Ltd
8
.
CE Statement
This is a class B product. In a domestic environment, this product may cause radio interferen
ce, in which case the user may be required to take adequate measures. This device is in comp
liance with the essential requirements and other relevant provisions of Directive 2014/53/E
U.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that
this device does not cause harmful interference (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Any changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help. The device has been
evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and your body.
