NuWave BruHub User manual

Owner’s Manual
NuWave BruHubTM
3-in-1 Coffee Maker

7
Owner’s Manual
IMPORTANT SAFEGUARDS
11. Do not let cord hang over edge of table or counter or touch hot surfaces,
including stove.
12. Do not place coffee maker on or near a gas or electric burner or in an oven.
13. To disconnect coffee maker, press the power button off and then remove
plug from wall outlet.
14. WARNING! To reduce the risk of re or electric shock, do not remove the
bottom cover.
15. Do not open lid during a brewing cycle.
16. The Single Serve Insert contains sharp pieces! Use caution when
assembling, disassembling, or cleaning parts.
SAVE THESE INSTRUCTIONS
Other Consumer Safety Information
This appliance is intended for household use only.
a) A short power-supply cord (or detachable power-supply cord) is provided to
reduce risks resulting from becoming entangled in or tripping over a longer cord.
b) Longer detachable power-supply cords or extension cords are available and
may be used if care is exercised in their use.
c) If a long detachable power-supply cord or extension cord is used:
1) The marked electrical rating of the detachable power-supply cord or
extension cord should be at least as great as the electrical rating of the
appliance;
2) If the appliance is of the grounded type, the extension cord should be a
grounding-type 3-wire cored; and
3) The longer cord should be arranged so that it will not drape over the
counter top or table to where it can be pulled on by children or tripped over.

8Owner’s Manual
PARTS FOR YOUR NUWAVE BRUHUBTM
1
2
3
4
67
Tank Lid
Screen
Part #: 45126 Carafe Base
Part #: 45121A
Drip Tray Base
Part #: 451213
Mug Tray
Part #: 451214
Charcoal Filter
Part #: 45116
Water Tank
Part #: 451201
BruHubTM Base
Part #: 45110
Charcoal Filter Holder
Part #: 451205
1
2
3
4
5
6
7
8
11
12
12
Plastic Thermal Carafe
Part #: 45121
SS Thermal Carafe
Part #: 45131 (optional)
11
9
8
2
Insert Chamber 9
5
Carafe Lid
Part #: 45121B
10
10

9
Owner’s Manual
PARTS FOR YOUR NUWAVE BRUHUBTM (Continued)
13
15
19
Hot Water Insert
Part #: 451204
Custom Brew Filter Basket
Custom Brew Insert with Filter Basket
Part #: 451203
Custom Brew Cap
Hot Water Cap
Single Serve Insert
Part #: 451202
Coffee Scooper
Part #: 45129
13
14
14
15 19
18
20
18
16
Custom Brew Insert
20
17
16
17

10 Owner’s Manual
BEFORE FIRST USE
Before rst use or when the appliance has not been used for an extended period
of time, run a cleansing brew at least once with water only:
MAX Fill Line
1. Fill the Water Tank to
the MAX Fill Line.
• Water Tank can be lled
while in the unit or
detached.
2. Insert Hot Water Insert into the
Insert Chamber.
• See Assembly for the
Hot Water Insert on
page 14.
3. Set full-sized Carafe on the Drip Tray Base.
4. Press “Power” to preheat.
5. Select “hot water” for the
coffee selection.
6. Select “carafe” for size
selection.
7. Press “brew”.
• Repeat steps 1-7.

11
Owner’s Manual
CHARCOAL FILTER HOLDER ASSEMBLY
For additional water purication, use the supplied (optional) Charcoal
Filter Holder with Filter. Note: The coffee maker will still operate
without Charcoal Filter Holder installed.
1. Before rst use, apply pressure to release tab to open
Charcoal Filter Holder compartment and
remove Charcoal Filter.
2. Flush Filter by running under cold tap water for 1-3
minutes before initial use. After ushing, allow the
Filter to drain completely.
3. Carefully place Filter back into compartment and
snap to close.
• Flat side (base) of cartridge must face down inside
Filter Holder compartment.
4.Insert the Charcoal Filter Holder into the Water Tank. The Filter Holder’s
base should sit rmly into the channel.

12 Owner’s Manual
WATER COMPARTMENT
Fill water directly in the Water Tank when attached, or remove rst.
To ll directly in the Water Tank:
1. Lift the Water Tank Lid up and pour
in water to appropriate ll line.
2. Close the Water Tank Lid.
• Coffee maker will not operate when tank
is removed or when there is no water.
To ll Water Tank when removed:
1. Lift Water Tank Lid and place to the side.
2. Lift Water Tank up to remove from the side.
3. Fill to appropriate ll line.
4. Slide Water Tank straight down, ensuring the hooks t snug with Water Tank.
5. Place lid back on top of Water Tank.
IMPORTANT: When raising
Mug Tray to a higher level,
insert into holes. Press down
to ensure Mug Tray is secure.
MAX Fill Line
Full Carafe
Half Carafe
12oz Cup
8oz Cup
MAX Fill Line
Full Carafe
Half Carafe
12oz Cup
8oz Cup

13
Owner’s Manual
With your NuWave BruHubTM 3-in-1 Coffee Maker, you can choose from three
different inserts to customize your coffee-drinking experience and preference.
Single Serve Insert
1. Line up dots with each other and
place Single Serve Insert into
the Insert Chamber.
2. Place pod into Single Serve Insert
until connected, indicating needle
has gone through.
3. Close down Single Serve Lid.
• Make sure lid is fully closed.
• Use Mug Tray on Drip Tray Base
and Screen for smaller cups and mugs.
• Use “8” and “12” sizes for Single Serve Insert.
Custom Brew Insert
1. Place Filter Basket inside
Custom Brew Insert.
2. Line up dots with each other and place
Custom Brew Insert directly down
into Insert Chamber.
3. Fill with appropriate amount
of coffee grounds.
4. Close lid.
• Use “8”, “12”, “half carafe” and “carafe”
for Custom Brew option.
• Always use NuWave’s customized carafe
when using the Custom Brew Insert.
ASSEMBLY FOR INSERTS

14 Owner’s Manual
ASSEMBLY FOR INSERTS (CONT.)
CARAFE ASSEMBLY
1. Place Carafe Lid on top of
Carafe Base.
2. Line up dots by turning
clockwise to lock into place.
Hot Water Insert
Line up dots with each other and place
Hot Water Insert directly down
into Insert Chamber. Close lid.
• Use Mug Tray on Tray Base for smaller
cups and mugs.
• Use “8”, “12”, “half carafe”, and “carafe”
for Hot Water Insert.

15
Owner’s Manual
FUNCTIONS FOR THE NUWAVE BRUHUBTM
Power Button:
1. Press “Power” button once to turn the unit on. There will be a blue
light next to “Power” button to indicate it is on.
• When you press the “Power” button, there will be a red light next
to “Preheating”. Once it has preheated, the red light will turn off,
indicating the water is ready to brew. Once it has preheated, press
“Brew”.
• Unit will beep when the brew is complete.
2. Press “Power” again to turn the unit off.
Coffee selection function:
This lets you select your favorite beverage with the push of a button.
1. Default is set for “regular”.
2. Press the “beverage selection” button once and the blue light
next to “bold” will be lit.
3. Press the “beverage selection” button again to change the
selection to “iced”, “hot water”, or back to “regular”.
• When “iced” is selected, half of the amount will be dispersed.
For example, instead of 8oz, 4oz will be brewed, making the
beverage more concentrated.
• Refer to Insert & Beverage Selection Charts for more information.