NVT Phybridge NV-PL-RMEC10 User manual

Quick Install Guide
PN: 451-2010-003-A
1
Rack mount kit for EC10/PL-08 Switches
Beyond PoE: Delivering Power over Long Reach Ethernet
NV-PL-RMEC10
Rack Mount Kit Includes:
1. 1 x 1.5U 19” rack
2. 4 x rubber feet
3. 2 x cable ties
4. 4 x screws
5. 4 x washers
Not Included:
EC-10, EC-10 power supply
PL-08, PL-08 power supply
Installation
1. Insert EC-10 or PL-08 switch into 1 of 2 slots in faceplate of rack
2. Apply rubber feet to back 2 corners of bottom of switch
3. Secure switch using screw and washer on left and right side of front of switch
Quick Install Guide

Quick Install Guide
PN: 451-2010-003-A
2
4. Mount power supply behind switch using cable tie secured through slots in base of rack. Orient the power
supply such that the AC inlet connector faces the back of the rack.
5. Connect power supply barrel connector to power jack at back of switch
6. Insert AC power cord into AC inlet connector on power supply.
7. Mount unit in 1.5U slot on 19” rack.
8. Connect AC power cord to AC power outlet.
Technical Support
The NVT Phybridge Technical Support Group is available to assist you with product installation.
Should you experience trouble with this equipment or for repair or warranty information, please contact NVT Phybridge Inc. at
+1 905.901.3633 or [e-mail] or [e-mail] .