Nyce Control NCZ-3041 User manual

How to Install a
NYCE Control Motion Sensor
STEP 1: INSTALL BATTERY
To open the
battery cover, use
a flathead
screwdriver in the
recessed slot as
shown.
Remove the packing tape, if
present, from the battery
cover and install the CR2
battery with polarity as
shown.
STEP 2: INSTALL DRIVER + IDENTIFY
Install the device’s driver:
Driver is named: DriverWorks_HA_Profile_MSensor.c4i
Download driver from: www.nycecontrol.com/support
or from Control4’s online database
Copy driver to My Documents\Control4\Drivers
Open Composer and add device to project
(Manufacturer = “Nyce Control”)
Identify the device by pressing the button 4 times while
its identify window is open.
The device’s 64-bit address should appear in the
identify window’s text box.
STEP 3: VERIFY DEVICE + CLOSE
Verify the device is sensing
motion.
The red LED should flash and
motion should be indicated in
Navigator’s and Composer’s
List View.
Snap the battery cover into
place.

Please visit our website if you have any installation questions www.nycecontrol.com/support
STEP 4: PLACEMENT GUIDELINES
STEP 5: INSTALL MOTION SENSOR
READING & WRITING ATTRIBUTES
To Read:
In Composer, under the Actions tab, click on
Read Attributes.
Wake up device with a double button press.
Check updated attribute value under the
Properties tab. The Attributes Status field
should read: “Attributes are up to date”.
To Write:
In Composer, change the attribute value (4-
65534 seconds) under the Properties tab
and click Set.
Under the Actions tab, click on Write
Attributes.
Wake up device with a double button press.
Check the Occupancy Attributes Status. It
should read: “Attributes are up to date”.
Install the Motion Sensor on a clean
surface using the 2-sided tape
provided.
The Motion Sensor can be installed on
a flat surface or in a corner.
It can be installed vertically,
horizontally or upside down.
Orient the Motion Sensor to best use
of its detection zones.
*all measurements are approximate
PRODUCT FUNCTION + LED INDICATORS
BUTTON AND LED LOCATION
Button Press
LED w/Press
Action
LED Action
Description
2 Times

Network Status


Not Joined
Joined
4 Times

Network Join


Join Successful
Join Unsuccessful
6 Times

Network Leave

Leave Successful
10 Times


Restore Defaults


Leave (if joined) and
Defaults Restored
No Action



Unsupported Command
Network Error, retry
Device Busy
Normal Operation

Motion Detected