Obbo MU-3600 User manual
1
Adjustment Knob
Adjustment Bracket
Armrests
Rear Flange
Your healthy living center
www.obbomed.com
Raised Toilet Seat
Model No.: MU-3600
Please carefully read through this manual before first use, and store it in safe place.
If you pass the product to another person, hand over this manual along with it!
IMPORTANT SAFETY INSTRUCTION
OVERVIEW
- Consult your physicians or doctors before use.
- The product is suitable to be used in private places or at home.
- The product is suitable to be used indoor only.
- The maximum capacity of this raised toilet seat is 135kg/ 300lbs.
- This product requires checking and reghtening on regular bases. Always ensure the seat is secured and stable before
applying weight to it. Reghten the seat as needed.
- User’s weight should be centered over the raised toilet seat, not too far from one side as the seat may p and result
bodily damage.
- The arms of this seat are designed to provide assistance when geng on and off the seat. Do not use the arms to
support full body weight, as this may result bodily injuries.
Failure to follow the above instrucons may result serious bodily injuries.
ObboMed assumes no responsibility for any damage or injuries caused by wrongful installaon, assembly, or use of
this product.
All below informaon serves to ensure the safety of user, read before use.
Please follow the instrucons below.
2
Please read all instrucons below before installing the product.
1. Clean your toilet before installing the product. The rim of the toilet bowl must be free of stains and residues in order
to ensure a secure fit.
2. Remove the product from the carton.
3. To install armrest, insert the armrests into the holes in the raised toilet seat. Insert screws with washers and ghten
by turning clockwise unl snug. Do not over ghten, it might damage the raised toilet seat.
4. Turn the gray adjustment knob counterclockwise.
5. Li the seat and lid on the toilet. (Some toilet may require removing the enre seat and lid to allow proper fit.)
6. Placed the raised toilet seat onto the rim of the toilet bowl with the adjustment knob facing forward. Make sure the
rear flange is under the edge of the rim, Fig. 1.
7. Make sure the raised toilet seat is resng in the center of the toilet. Secure the raised toilet seat by turning the
adjustment knob clockwise. Do not overghten as the thread on the adjustment bracket may be damaged.
Always test the stability of the raised toilet seat before use.
Fig. 1
ASSEMBLY AND HOW TO USE
REMOVAL
1. Turn the adjustment knob counterclockwise unl the raised toilet seat is loose.
2. Li the front of the toilet seat and pull to remove the seat from the toilet.
SPECIFICATION
Model No.: MU-3600
Name: Raised Toilet Seat
Material: ABS Molded Plasc
Size: Fits most toilet seat
Weight Capacity: 135kg/ 300 lbs
Technical specificaons are subject to change without noce.
3
CARE AND STORAGE INSTRUCTION
LIMITED LIFETIME WARRANTY
- Inspect the safety bar clamp for wear and damage regularly.
- Use mild soap and water soluon to clean the safety bar. Rinse with clean water and dry with so cloth.
Do not use abrasive cleaners to any part of the product.
- Store in cool and dry place if not in use. Long exposure to direct sunlight and heat may damage the rubber accessories.
- Do not make aempts to repair the product.
- Please bring the product to the dealer or the service center.
- Be careful when handling the product in order to avoid damage to the equipment.
- Check regularly and stop using if damage is present.
This warranty is extended only to the original purchaser/ user of our product.
ObboMed warrants the frame to be free of defects in materials and workmanship for the lifeme of the product. In the
event of a defect covered by this warranty, we will, at our opon, repair or replace the device.
This warranty does not cover device failure due to owner misuse or negligence, or normal wear. The warranty does not
extend to non-durable components, such as rubber accessories, casters, and grips, which are subject to normal wear and
need periodic replacement. No guarantee is provided when the product is not installed/ operated according to this
manual, used for other purposes or careless use of the product.
For repair and warranty processing, please include the following documents when you send in the product:
• A copy of the receipt with purchasing date.
• A reason for the claim or descripon of the fault.
DISPOSAL
Disposal of packing and product aer end of lifeme.
Deliver all packing materials at a collecon point or in the appropriate bins for recycling. For further queson please
contact local recycling office.
Distribuon by ObboMed Group:
Webshop: www.obbomed.com
Europe:
Morseweg 11, 8503 Ah Joure
The Netherlands
Mail: [email protected]
United States:
1210 E Lexington Ave,
Pomona, CA 91766, U.S.A.
Mail: [email protected]
Australia:
39/3 Kelso Crescent Moorebank,
NSW 2170, Australia
Mail: [email protected]
ObboMed® is registered Trademark of ObboMed Group.
DISTRIBUTION & SERVICE
Table of contents
