The keys on the back of the
monitors allow you to adjust the
proximity between them. Move the screen
down, up or to
the sides to
position it at the
desired angle.
The screens have
independent
settings. Rotate the screens to
position them as desired.
For the
safety of your
equipment,
always leave
your monitors
in parallel with
the foot of
the stand.
9PROHIBITED SITUATIONS
CLEANING AND
MAINTENANCE:
Plastic:
Wash with mild soap and water using a
soft cloth. Do not use chemicals or
abrasives, especially bleaches, since they
may damage the surface of the plastic.
Steel Painted:
Remove the dust with dry flannel or soft
cloth, weekly, as the accumulation of
dust stimulates the appearance of rust.
Do not use sponges or harsh objects,
chemicals with solvents and alcohol.
CARE
- Avoid direct sunlight;
- Product for internal use.
For more information visit our website: useoctoo.com
4
Disconnect
all cables
from the
monitor.
1
Move the flexible
rings leaving them
at the height you
want your monitors
to be installed.
32
56
78 9
Screw the
bracket on
your monitors.
Make sure
the marker
located
in the center
front is up.
OCTOO, Inc
600 S Federal Highway, Suite 211 - Deerfield Beach - FL 33441
561 774 0669
MANUAL OF
ASSEMBLY AND USE:
Clipway2
Attach the stand
to the tube, the
screens parallel to
the foot and use
the key on the
back to secure it.
Use an Allen wrench
to tighten or loosen
the screws by
adjusting the tension
in order to facilitate
the movement of the
monitor and ensure
its stability.
ONLY IF NECESSARY
Pass the cables
through the side
opening of the tube
and pass them to
the bottom opening
where it is used to
attach the base to
the tube. Finish by
attaching the cap
on the bottom of
the tube.
Fit the tube to
the base and
put the screw.
