OE WITNESS OEW-ST60 User manual

User Manual
OEW-ST60 WIFI CAR DVR
2 Year Warranty
Made In China

2
Table of Contents
Introduction.................................................................................................................3
(A） Disclaimer............................................................................................................4
Important Safety Information.........................................................................4、5
(B)Customer Guide....................................................................................................6
Light Status..................................................................................................................6
Memory Card..............................................................................................................6
Device Voice Prompt................................................................................................6
(C)Technical Specifications.....................................................................................7
(D)Product Contents.................................................................................................7
(E)Device Instructions...............................................................................................8
(F)Installation...............................................................................................................8
(G)Operation & LED Status Instructions............................................................9
(H)OE Witness Smart Phone App Installation...............................................10
(I)OE Witness Smart Phone App Operation...................................................11
(J)FAQ & Answers...................................................................................................14
OE Witness Warranty Terms and Conditions................................................15

Thank you for purchasing this OE Witness vehicle specific, precision
engineered dash cam.
This instruction manual contains basic information on how to install
and operate your OE Witness dash cam.
Before using your OE Witness dash cam, we recommend that you
read and understand this manual to ensure you get the maximum
from your purchase and use it correctly.
Please note that to improve your experience, the contents of this
manual are subject to change without prior notification.
Before inserting the SD card into the dash cam please ensure the SD
card is formatted on your computer.
INTRODUCTION
3

ADisclaimer
4
The OE Witness WIFI hidden style digital video recorder (DVR) is
designed for the recording of video and taking of photos when driving.
OE Witness takes no responsibility for the loss, damage or corruption
of data due to incorrect operations. We strongly advise this device be
used with a memory card of Class 10 or above.
Please note that loss, damage or corruption to data can occur as warned
below:
Removal of the memory card whilst device is operating/recording.
Abnormal operation whilst device is operating/recording Physical severe
damage to the device itself.
Important Safety Information and notes of caution
DANGER – Failure to comply to the following instructions can result
in property damage, serious injury or death.
The basic instructions below are for yours and the dash cams protection:
Please use this device according to the associated laws and regulations
of the relevant country where used.
Please do not disassemble, modify or repair the dash cam yourself. This
can cause fire, electric shock or product malfunction. For repair or inspection
please contact your supplier.
If any foreign matter contaminates the dash cam, disconnect the product
immediately. Contact your supplier for inspection or repair.
Please ensure that the device is installed and tested by professionals
properly prior to use.
Please fully test all operations before the device is used on the road.
Please do not touch the dash cam whilst driving. Doing so can result in
an accident. Stop and park your car safely before touching.
Please do not use this product if the power cord is damaged or modified
in any way. Only use the power cord supplied with this product.
Damaged or modified power cord can cause fire, electric shock or product
malfunction.
Please do not control or operate the dash cam with wet hands as this
can cause electric shock.
Please do not install this dash cam in an environment that is of high
humidity, or combustible gases or liquids. Doing so can cause explosion
and/ or fire.
Do not spray liquid or wax directly onto the dash cam when cleaning the
vehicle. This can cause fire, electric shock or product malfunction.
If you detect smoke or unusual smell from the dash cam disconnect
immediately. Contact your supplier for inspection or repair.

5
Please keep the product away from infants, children or pets.
Please ensure when installing the product the correct input voltage is
supplied to the dash cam. Failure to do so so can cause fire, explosion or
product malfunction.
Please ensure the power cord is installed firmly to avoid it being disconnected.
Failure to do so may cause fire.
Please make sure the product is installed correctly to avoid vibrations
causing the product to fall and cause physical injury.
Please make sure this user manual is kept safe.
Please be aware that when facing direct sunlight, exiting a tunnel or night
recording in low level light, can cause the quality of video to deteriorate.
Please be aware if the power cord is cut or damaged due to an accident
video may not be recorded.
Please note that excessively tinted windscreen can distort the quality of
video.
Please be aware that SD cards are consumable items and should be checked
regularly and replaced if necessary.
Please clean the lens regularly so as to not affect video recording quality.
Please be aware if the vehicles engine is not on and the device is powered
on by ignition power please be aware that this can cause the vehicles
battery to be drained of power.
Normal working temperature for the device is -20 degrees to 70 degrees
Celsius. Please do not use the device at high/low temperature or under
high moisture to avoid working failure.
The device will be updated with new and improved features and uses
which can result in slightly different operations differing from this manual.
Notice:
This car digital video recording device is for the sole use of driving
assistance and it will NOT replace the actual manual operation of the
vehicle. OE Witness will NOT be held liable for any accident or dispute
caused.
The video or photo data taken by the device is for use of recording only.
OE Witness takes no responsibility for any dispute caused by the illegal
transmission of data which may contain privacy information.
The video or photo data taken by the device is just for reference when
there is an accident, offence or incident and its responsibility is subject
to the related road traffic department or law enforcement agency. OE
Witness takes no responsibility for the cases above.

B Customer Guide
Please read and understand the notes below to enable correct operation
of the device.
Light Status
Turn on the vehicle ignition and wait for the device to power up:
If the RED light is constant ON and the BLUE light flashes, the device is
working normally.
If the RED and Blue light flash quickly at the same time, the device is in
emergency recording mode.
If RED light flashes and BLUE light is constant ON, the device has no memory
card or cannot detect a memory card.
If the RED light flashes quickly and the BLUE light flashes slowly, the
device has malfunctioned or crashed. Please switch power off and then
restart to perform system reset.
After the restart and reset procedure is complete please ensure that
the device is working correctly with RED light constant ON and BLUE
light flashing.
After the power is turned off please ensure the lights on the device are
also turned off to confirm the DVR is automatically turned off.
Memory Card
The user is advised to format the memory card used in the device regularly.
Format can be performed by Cellphone via the OE Witness dedicated
App or alternatively by computer. This will ensure the memory card is
kept in good working order and clear any memory chips which can affect
its long term performance capability.
It is advised that a high speed Class 10 memory card is used in conjunction
with this device, if upgraded or replaced. This product is supplied with a
16GB Class 10 Memory card.
Device Voice Prompt
On first time start up the device will give the voice prompt “please
synchronize the time with cellphone”.
If the device is not connected to a cellphone on start up the device will
give the voice prompt “please synchronize the time with cellphone”.
If the device is connected to a cellphone and the memory card is formatted
then there will be no voice prompt on the next start up.
If the device detects no memory card or abnormal reading of the memory
card the device will give the voice prompt “please insert SD card”. If
the memory card is 95% full the device will give the voice prompt “please
change SD card”.
If the SSID and password have been changed and are then forgotten, the
user can remove the memory card and press the button at the same
time to reset the SSID and password to default.
6

Chipset Frequency
DDR Memory
Video Resolution
Lens Angle
Lens Aperture
Video Compress Mode
Memory Capacity
Working Temperature
Storage Temperature
WIFI Protocol
Input Voltage
Working Current
Working Voltage
Rating Power
Standby Current
SD Card checking
Supported Language
600MHz
512MB
1080p@30fps,720p@30~60fps
155
F2.0
H.264
8/16/64/128G (Standard Version is 16GB)
-20℃~70℃
-30℃~75℃
2.4GHz IEEE802.11b/g/n
less than 300mA
less than 1mA
Chinese(Simplified/Capital) ,English
less than 3.6W
NAME Parameter
12V
10.5V~24V
Packing List for products:
Number
1
2
3
4
5
6
Name
Main Unit
Manual
Prolonged power cable
16GB Memory Card
Optional Memory Card (GB)
Optional Rear Camera
Quantity
1
1
1
1
32 64
Yes No
C Technical Specifications
DProduct Contents
SD Card remaining storage/lifespan
can be viewed on APP
7

Take off the original plastic
part from the rear mirror
Wiring diagram for reference
2
1
3
4
5
1
Lens
2
On/Off and Indication Light
4
Reset
3
Memory Card Socket
5
USB Interface
Install the Car DVR to the
rear mirror
Installation Position
Upwards
Notice: This is the example of the Car DVR Installation
diagram for Audi ,and there will be different Car DVR
outlook for different car brands or models, which will not be
listed all here.
Take it out
E Device Instructions
F Installation
Fuse Box Diagram
Black Cable(GND)
Fuse Box Diagram
Yellow Cable(B+, Power
is not cut off after car is
power off)
Red Cable (ACC, Power is cut
off after car is power off)
This diagram is just for reference and please refer to the connection by the professionals.
8

G Operation & LED Status Instructions
Button & Indication Light Definition
Name Operation Definition
Button
Red & Blue
Indication
Light
After it
´ s on, Short Press
（With SD Card) Lock/Unlock
After it
´ s on, Short Press
（Without SD Card)
Resume to Factory Setting
(Including SSID)
After it ´ s on, Long Press Turn off the unit
Red Light on, Blue Light
flashes
Red Light and Blue Light
Flash
Red Light Flashes, Blue
Light on
Red and Blue Light are on
Power & SD Card :Normal
Emergency Video Record
SD Card un-inserted
Recording stop, SD
Card abnormal
9

HOE Witness SmartPhone App Installation
The Car DVR original factory setting is as below:
WIFI ID: OEWitness-XXXXXX XXXXXX :As Device Code
WIFI Password: 1234567890
10
Search “ OE Witness” on App Store(For IOS) or on Google
Play (For Android)