Oliver Hemming Robin Installation guide

Robin
Bl
ue
to
ot
h Speaker
A
larm Cloc
k
Instructions and
W
arranty

Introduction - English
Robin is an active Bluetooth speaker with an analogue alarm clock.
The simple intuitive controls make Robin very easy to use.
Please read this booklet carefully.
The audio unit is powered by mains electricity and the clock by an internal
re-chargable battery, so the clock will keep working when the mains power is off.
What’s you should find
+
The Robin Unit Power Cable and
Transformer Box plug
The Controls
Bluetooth pairing Play/Pause Volume down Volume up
Alarm setting
button
Clock time
setting button
Snooze & Night Light Alarm on/off
USB C AND A FOR Charging only Clock on/off Power Cable Passive Bass Speaker

Unpacking and Getting Started
1. Carefully unpack the contents of the box. Check that it is all in good condition.
2. Check that the power cord has the correct plug for your country.
3. Connect the 12V transformer plug to the cable at the back of the Robin unit.
4. Plug the transformer into the mains power socket of the room, and make sure the
power is on.
5. Switch on the clock power at the small switch on the back and correctly set the
time using the time setting knob.
+-
Connecting to bluetooth and playing audio
1. Press the Blue pairing button for 2-3 seconds so that it starts flashing.
2. Then open your Bluetooth settings in your phone and search for “Oliver Hemming
Robin Speaker Clock” in the available devices section, and then connect to it.
3. Turn up the volume on your phone and on the top of the Robin to maximum.
4. Play your audio from your phone, and adjust the volume on the Songbird or with
your phone.
5. For best results, turn up the volume on your phone to about 70% of its maximum
and then adjust the Robin using the set top controls to the volume you want.
If the output volume is too low from your phone then you may get poor quality
audio playback.
6. Use the Play / Pause either on the Robin or in your phone controls.
7. If you have no sound, check the volume in your phone and on the set top
controls. Check you have power and a bluetooth connection. Check that your
audio media is playing and not in pause mode by pressing the

Using the Alarm clock, snooze and night light
1. Set the alarm time by turning the alarm set button on the back of the Robin unit,
like a normal alarm clock.
2. To switch on the alarm, make sure the alarm on/off button on the top of the
Robin unit is showing a green LED light.
3. To switch off the alarm press the alarm button so that the Red LED indicates off.
4. To use the night light, press the snooze / light button and the light will come on.
5. To activate the SNOOZE, press the SNOOZE button when the alarm is ringing and
the alarm will stop and restart again after 5 minutes.
USB Charging
1. On the back of the Robin there are 2 USB ports for charging your devices. One
is USB A and the other is USB C. They can charge a normal smart phone, Ipad or
similar tablet. They are there for your convenience so you can sleep and wake to
a fully charged device.
2. You can also charge your device at the same time as you are using it to play
audio. This means that you can play music without running your battery flat.
NOTE: the snooze and night light share the same button, but they do not affect
each other’s function.

Maintenance and Cleaning and General Use
1. From time to time, check all the power cables are in good condition and avoid
using them if you see any damage. Be safe!
2. The body of the Robin can be kept clean simply by using a cloth which is slightly
damp, do not use a “wet” cloth. The body is painted so it doesn’t need any wax
polish, just a simple wipe will do. The same applies to the clock lens, a simple wipe
with a damp cloth is sufficient. Do not use any abrasive cleaning pads or you will
scratch it.
3. Position the Robin out of direct sunlight so that it does not discolour the finish or the
clock dial or get too hot.
4. Do not let it get wet and keep it in a dry and not in a humid room, such as
bathroom. Dont use it outside.
5. Do not place it near a cooker in the kitchen or anywhere it may become hot.
6. Do not play the Robin at fullvolumefor prolonged periods of time, it’s not designed
to be a party speaker and you may damage the electronics.
Your Warranty
Please inspect the product at time of purchase for any cosmetic defects. It is
guaranteed from the date of purchase. The length of the warranty is stated at the
time of purchase. This product has a warranty which is serviced by the seller you
bought it from and it should be returned to them in the event of a claim. The warranty
will be subject to a few simple rules and those include the following.
1. The product must be returned to the distributor with its original receipt of purchase
within the warranty period.
2. The guarantee covers defective workmanship that stops the product from working
correctly, a defective clock mechanism or a malfunctioning audio amplifier or
speaker unit etc.
3. The warranty does not cover any damage due to misuse of the product, so do
not play the Robin at full volume for prolonged periods of time, its not designed to
be a party speaker and you may damage the electronics.
4. Damage due to being dropped or falling, or being in a harmful environment.
5. The warranty does not cover any cosmetic damage such as scratches or a
broken clock lens.

A
u
di
o
P
ower out
p
ut 1
0W
65mm
f
ull ran
g
e dr
i
ver
SNR S
ig
nal to no
i
se rat
i
o ≥95db
110V / 220V external trans
f
ormer
Fre
q
uenc
y
res
p
onse
80
Hz -17,
000
Hz
Sta
i
nless steel
g
r
i
lle
Di
g
ital amplifier ≤0.1% distortion
Bluetooth v4.2 w
i
th a ran
g
e o
f
10M
7
0% volume limitin
g
option
S
ockets
T
yp
e U
S
B A &
C
- 5V
/2
am
p
s
f
or h
ig
h power char
gi
n
g
on
ly
S
ize
(
w x h x d
)
Si
ze: 1
80
x
55
x
90
mm
7” x 2 1/4” x 3 1/2”
Controls
Power
Bluetooth pairing
Volume
Play / Pause
Night light
Snooze
Alarm set
Alarm Clock
Silent sweep action movement
3 step ascending alarm tone
Snooze function
Night light
One Time Alarm Feature
Specifications
+ -
7
x
2
.
1/4 x
3
.
1/2
W
e
ig
ht: 1.2k
g
or 2.6Lbs

Troubleshooting Problems
The Clock
1. If the clock is not working, check the clock on/off switch at the back of the Robin
is ON.
2. If the alarm is not working, check that the alarm on/off switch is showing a green
light.
3. If the snooze is not working, check that the alarm is on.
The Speaker and Audio
You can control the audio sound from both the Robin or your phone, the control levels
of both will affect the quality and performance.
If you have no sound at all, then try the following:
1. Check that the set top bluetooth light should is on, which means its connected.
2. Turn up the volume on the top of the Robin using the + control until it beeps.
3. Turn up the volume on your phone to maximum.
4. Check you have a Bluetooth connection to the “Oliver Hemming Robin Speaker
Clock” in your phone.
5. Try pressing the Play / Pause button, on both the Robin and your phone,
you maybe in pause mode.
If the quality of the audio sounds poor or muffled. Then its likely the input signal is not
strong enough. Turn up the volume of your phone to about 70% of its maximum and
then adjust the volume on the Robin so that the sound is as you want it. If the volume
on the phone is not loud enough then the Robin amplifier cannot clearly reproduce
the music.
The Usb sockets
The 2 USB points are for charging only, they are NOT audio inputs. Their output is
5V/2amp and they can charge a smart phone or a tablet like an Ipad.
The Bluetooth Pairing
1. Switch on the bluetooth in your phone and stand about 3 feet or 1m away.
2. Make sure no other nearby device is connected which may stop your connection.
3. Make sure that you press the Blue Pairing button on top for 2-3 seconds so that it
is flashing and then search in your phone’s Bluetooth settings for “Oliver Hemming
Robin Speaker Clock” in the available devices section, and connect to it.
4. If it still won’t connect, switch your bluetooth on and off in your phone and try
again. Remember that pairing can only happen when the blue light is flashing.
5. No passwords are required so it should be a simple click and connect process.
6. Try all the above with another phone or bluetooth device. Yours may be broken !
The Robin will auto connect to the same device it was connected to before, so you
don’t need to keep reconnecting as long as you are within 6-10 feet or 2-3 meters.

Robin
bluetooth speaker alarm clock
www.oliverhemming.com
Oliver Hemming and the mark and Robin are all internationally registered trademarks 011156262, 01117338, 016771479
The Robin bluetooth speaker alarm is a registered design 1400973.8 & 1701498.4 and has patent applied for.
Robin Series A
Oliver Hemming
Simple elegant solutions
Exquisitely detailed

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.