Olivetti FS1 User manual

Floor Stand
FS1
Doc Code: DOC0252
August 2020
PUBLICATION ISSUED BY:
Olivetti S.p.A.
Telecom Italia Group
Via Monte Navale 2/C - 10015 Ivrea (TO)
Copyright © 2020 Olivetti
All rights reserved
Floor Stand FS1
Assembly quick guide

FL X1 Manuale Utente 2
ASSEMBLY OF FS1 FLOOR STAND FOR OLIVETTI FL X1
MAIN FEATURES AND REGULATIONS
The floor stand for Olivetti FL X1 termoscanner allows a height regulation between 150cm and 170cm and a 11°
tilt regulation.
Optionally it can be fixed to the floor through the two holes in the base
Height regulation
Tilt regulation

FL X1 Manuale Utente 3
PACKAGING CONTENT
Base
Screw and washer for the height regulation
Adjustable rod
Tilt adjustment bracket
Cable cover
Cable cover plate

FL X1 Manuale Utente 4
n ° 2 M8x30 countersunk head
screws with hexagon socket
n ° 2 M8x20 rounded head
screws with hexagon socket
n ° 6 M4x12 rounded head
screws with cross insert
n ° 4 adhesive felt for floor
support
n ° 1 adhesive male / female
velcro for fixing termoscanner
power supply
n° 1 base
n° 1 screw and washer for the height regulation
n° 1 adjustable rod
n° 1 tilt adjustment bracket
n° 1 cable cover
n° 1 cable cover plate
n ° 2 M8x30 countersunk head screws with hexagon socket
n ° 2 M8x20 rounded head screws with hexagon socket
n ° 6 M4x12 rounded head screws with cross insert
n ° 4 adhesive felt for floor support
n ° 1 adhesive male / female velcro for fixing termoscanner power supply

FL X1 Manuale Utente 5
ASSEMBLY INSTRUCTIONS
1. fix the base to the adjustable rod using the n ° 2 M8x30 countersunk head screws with hexagon socket
2. screw the screw and washer for the height regulation to the adjustable rod at the desired height

FL X1 Manuale Utente 6
3. assemble the Tilt adjustment bracket to the cable cover and the wall mount bracket included with the
termoscanner FL X1 (the wall mount bracket is in the termoscanner packaging, not in the stand
packaging) using n ° 4 M4x12 rounded head screws with cross insert
Assemble the parts taking care that the cable cover opening will be correctly aligned with the small screw
holes in the wall mount bracket according the below image.
4. fix the assembly built in the previous step to the adjustable rod using the n ° 2 M8x20 rounded head
screws with hexagon socket
Wall mount bracket for
Olivetti FL X1
termoscanner (included in
termoscanner box)

FL X1 Manuale Utente 7
5. pass carefully the termoscanner cables in the opening as shown in the below picture
6. fix the termoscanner using the two Allen screws included with the termoscanner
7. block the termoscanner tilt tightly by the screws

FL X1 Manuale Utente 8
8. plug the power supply cable to the termoscanner and place the cables inside the cable cover, using the
cable cover plate and n ° 2 M4x12 rounded head screws with cross insert to close the box
9. optionally it is possible to fix the power supply to the adjustable rod using the n ° 1 adhesive male /
female velcro for fixing termoscanner power supply. Connect the power supply of the termoscanner to a
power plug to switch on the system.