INSTALLATION
Tools:
Adjustable Wrench Plumbers Putty Teon Tape Rags
Model Number: K-5120, K-5121, K-5130, K-5131
K-5150, K-5160, K-5161, K-5170, K-5171
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.
OLYMPIA FAUCETS, INC.
Interchange City Distribution Center #20
1277 Heil Quaker Boulevard
La Vergne, TN 37086
(888) 772-7701
www.olympiafaucets.com
Installation Steps:
Two Handle Kitchen Faucet
(1) Shut off water supplies. Remove old
faucet. Clean mounting surface in preparation
for new faucet.
(2) Apply plumbers putty under the base
gasket, with base gasket on the bottom of
deck plate, place faucet in position on the
sink. Slide washers on shanks and secure the
locknut to the shanks from underneath of the
sink. Place side spray holder in position on the
sink, tighten locknut from underneath of the
sink to secure side spray holder.
(4a) when using ball-nose exible supplies
to connect faucet to water supply valves, slip
coupling nut onto exible supply. Ball-nose
coupling will go partially into shank. Tighten
coupling nut (DO NOT OVERTIGHTEN).
Install opposite end according to
manufacturer’s instruction for both tubes.
(4b) when using stainless steel braided
faucet supply hose; this faucet requires one
end of the supply hose to have a ½” female
IPS connection. The other end of this supply
hose must match the thread on the water
supply valve under your sink. Once you’ve
identied the required size, carefully follow
the manufacturer’s installation instructions for
each hose.
(5) Important: After installation is complete,
remove aerator. Turn water supplies on and
allow both hot and cold water to run at least
one minute each. While water is running,
check for leaks. Turn off water and replace
aerator.
(3) Lead side spray hose through side spray
holder. Tighten side spray hose to faucet body
from underneath of the sink.
