Olywiz ATS-200 User manual

Digital Two-way Radio
Fujian Wanhua Electron & Technology Co., Ltd.
ATS-200,ATS-100

Please read this manual carefully before using this transceiver
Note

QuantityDescription Dimensional Sketch
Unpacking and Checking Equipment
CONTENTS

CAUTIONS:
Preparation
Antenna
Installation
Removing the battery

Getting acquainted
Power on/off
Adjust the Volume
[Power on]
[Power off]
Calling
Basic Operation
Select channel
Note:
External interface:
Indicator light:
Speaker:
Microphone
Battery pack:
Belt clip
PTT key:
Monitor key:
Group Call key:
Antenna
Battery lock

Low Battery Warning
Auxiliary Function in Analog Mode

Trouble-shooting GuideAuxiliary Function in Digital Mode

Technical Specifications
406.1~470MHz

FCC Warning
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
RF Exposure complianceStatement and operating instructions
The device has been tested against the SAR limit (8W/kg). The highest SAR value reported
under this standard during product certification for use at the Face up is 1.042W/kg and when
properly worn on the body is 1.730W/kg. This device was tested for typical operations.
The device only supports simplex-mode and transmitting is no more than the rated duty cycle
factor of 50% of the time. For hand-held operation, the radio should be held at least 25mm from
the user's face. The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not satisfy these
requirements may not comply with RF exposure requirements, and should be avoided. Use only
the supplied or an approved antenna.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.