OMEGA AIR MDHI User manual

Omega Air User Manual MDHI Manometer Assembly Kit v1.01 eng
Installation manual
MDHI
Please read the following instructions carefully before installing assembly kit into service. Trouble free
and safe operating of the assembly kit can only be guaranteed if recommendations and conditions
stated in this manual are respected.

MDHI - Installation manual
2
Installation
NOTE
Installation of differential pressure gauge is possible only if filter housing is equipped with
“connections for measurement of differential pressure”.
When installing the differential pressure gauge, make sure that it is correctly connected to the
filter housing with the supplied hoses. Be sure that inlet connector of filter housing (marked with
[+]) is connected to that side of manometer which is also marked with [+] sign. The outlet
connector of filter housing has to be connected to [-] side on the manometer.
In case of incorrect connection, the differential pressure gauge will not work.

MDHI - Installation manual
3
Example of installation
Proper installation of MDHI manometer is shown on the two pictures below. Position of the
manometer can be adjusted till there is no change on the shape of the tubes. Tubes are designed
only for the weight of the manometer, adding any additional load is strictly prohibited.

MDHI - Installation manual
4
OMEGA AIR d.o.o. Ljubljana
Cesta Dolomitskega odreda 10
SI-1000 Ljubljana, Slovenia
Tel.: [phone]
Fax.: [phone]
E-mail: [email protected]
www.omega-air.si