OMG Smart Panel User manual

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
Walnut Backer
x1
White Backer
x1
Sliding Door Cabinet
x1
LED Lit Floating Shelf
x3
LED Header Halo Light
x1
4-Way LED Splitter
x1
LED Power Driver
x1
6ft 14 Gauge LED Extension Cord
x1
5/8” Signage Stand-O
x4
Heavy-Duty Furniture Leveler
x2
6” Adjustable Leg
x2
5mm Comrmat Screw
x6
4” Deck Screws
x15
USB Power Grommet
x1

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
5/8” Signage Stand-o
*Wood screw through base of
stand-o into guide.
Heavy-Duty Furniture Leveler
1

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
2

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
5mm Comrmat Screws
3

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
4” Deck Screws
White backer is NOT
attached; held in place
by shelves. Be sure to
line up USB Power
Grommet Hole
Feed LED shelf wiring
through pre-cut access
holes before securing
shelves.
Once sheles are in place,
feed USB Power Grommet
wiring through the access
holes and press in to
secure
4

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
* Mount Halo Light to the top of the panel
with supplied hardware
5

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
6
1) Connect 6ft LED extension cord to Halo Light
2) Connect extension cord from Halo Light and
the 3 shelf lights to the 4-way LED splitter
(Cord lengths not to scale) 3) Connect splitter to driver
*Driver can be concealed inside the sliding door
cabinet through cut outs on the panel

Smart Panel Assembly Guide
© 2018 | Bill Gerber | [email protected]
7
* Install tablet mount so the tablet is
centered between the top and middle
shelves
* Left edge of tablet should line up with
the edge of the shelves
* Run cord through USB Power Grommet
opening, NOT into one of the power
sources