
H I D
STEP 1 –Screw the four glass
clips to the back panel.
STEP 2 –Using the 26mm bolts
screw the steel frames to the
back panel with the largest
frame at the top. NOTE : make
sure the threaded holes on the
front bar of the top frame are
facing up.
STEP 3 –Using the 13mm bolts
attach the left and right legs to
the front of the steel frames.
STEP 4 –Stick the gel pads to the
two lower steel frames, screw
the glass rests in to the holes at
the front of the top steel frame,
once in place press a gel pad into
each glass rest.
STEP 5 –Screw the cam shafts
into the two large silver rings on
the underside of the top piece of
glass just a fraction over finger
tight.
STEP 6 –Place the top glass on the unit with the
cam shafts sitting inside the holes at the top of
the front legs, insert cams at the back of the
legs and tighten with a screwdriver, with the
remaining 36mm bolts tighten the back of the
top glass down to the steel frame from
underneath.
STEP 7 –Insert the two
remaining pieces of glass on the
middle and bottom frames, once
glass is in place lock off glass
clips with a screw driver. NOTE :
one sheet of glass is slightly
larger than the other, the larger
goes at the bottom.
Parts Required : G –6 – 7 B –D –F –2 H –I –1 8 –9
A - 4 5 –3 C –E
G
6 – 7
B
D
F
HI
A
C
E
A