INSTALLATION
The OneRemote PowerLink Speaker Adaptor is easily installed:
1. Connect the speakers with PowerLink cable(s). Not included.
2. Connect the two sound sources with appropriate cables. Not included.
3. Connect the mains adaptor.
CABLE QUALITY
Be sure to use good quality PowerLink cables, preferably the double-shielded type, especially if
long cables are used. DO NOT use un-shielded cables for any connection.
PowerLink Cable MKII with 4-wire connections is not recommended.
Poorly or non-screened cables pick up noise from the surroundings.
AUX SOURCE NOISE REDUCTION
The AUX input can connect to any audio source. A controlled line output from a
preamplifier is one type of signal, a headphone output from a TV is another
type.
Use the two NR DIP switches on the OneRemote Powerlink Adaptor to match
the source and thereby reduce noise. Both the switches must be either up or
down. Use the position giving the best result.
If noise disappears when pulling out the AUX jack, the noise is either being picked up from cables
or the quality of the source is poor.
In rare setups a humming low pitched noise can appear due to problems with ground planes. If
this occurs, an audio transformer can solve the problem.
AUX SOUND LEVEL
Use the two potentiometer adjustments to align the levels of the PowerLink
and AUX sources.
This adjustment also sets the maximum volume for the AUX source.
