Ops-Core NVG Snap Shields User manual

For use with AN/PVS-15 (M953)
Night Vision Binoculars only.
© OPS-CORE 2016
NVG SNAP SHIELDS
OPERATOR’S MANUAL
UM-1021 REV. A
CLEANING AND CARE
1. Spot-clean with a mild detergent and water.
2. Visually check the entire Snap Shield for signs of wear or breakage.
3. Clean dust and dirt by using air pressure.
4. Check that the snap mechanism works properly.
NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE
REPLACED BEFORE USE.
MAINTENANCE

INTRODUCTION INSTALLATION PROCEDURE
ABOUT YOUR NVG SNAP SHIELDS
This manual covers the installation and basic operating instructions for the
Ops-Core NVG Snap Shields. The snap shields are designed to t the AN/PVS-15 Night Vision
Binocular. The snap shields feature a pivot mechanism that snap onto the binocular for secure
and stable attachment.
NVG SNAP SHIELD KIT INCLUDES:
(1) Left Snap Shield, (1) Right Snap Shield
FEATURES
•Locking mechanism secures to binoculars, pivots quickly and smoothly
•Tool-less installation, can quickly don and doff without removal of the helmet
2ALIGN
Align the inside of the snap shield to the outermost
edge of the binocular tube. Be sure to align the
pivot mechanism to the bottom of the tube.
3SECURE
While holding the inside of the snap shield to the
tube, carefully rotate the snap shield to the closed
position. Be sure to align the snap mechanism and
insert fully.
4REPEAT
Repeat steps 1-3 on the remaining snap shield.
To release, repeat step 1.
1PREPARE
Press rmly on the release mechanism and pivot
open the snap shield.
Pivot
Mechanism
Lock Mechanism Release Mechanism
Pivot Mechanism