10. Detailed Description
Energy-efficient, cool running, quiet and virtually maintenance-free. Integral 40W LED lamp
provides bright, white light and typically lasts 100,000 hours. Low power consumption.
Compatible with accessories and wheels such as the Clip-on Prism. Requires Wireless Wheel
Rotator 22614 or 22613. Not compatible with Wheel Rotators 22335, 13170, 16570 and
20685. Can be used on a table top (under supervision). Directly connect your own switches
to stop/start the rotated image. With 85mm lens. 1200 Lumens. Weight: 3.3kg
11. Safety
Always supervise the use of this product.
Please check the item carefully for any damage that may have occurred during
shipping. If the carton appears damaged, carefully check the shipping carton for
damage and be sure all accessories necessary to operate the unit have arrived intact.
In case of any difficulties, please contact ROMPA®.
It is highly advisable that you read the full instructions before use. Keep the
instructions in a safe and accessible place so that can be read as required.
The projector should be used in dry indoor environments only - do not expose to rain,
moisture or liquid or place near fabrics or combustible materials. Never immerse the
projector in water or liquids. Avoid damp, excessive heat, humidity, dust and
vibration.
Mount the projector in a safe and stable manner in an area that allows proper ventilation.
Do not block the air opening of the product or drop/insert anything into this opening.
The appliance should be situated away from heat sources such as radiators, heat
registers, stoves or other appliances (including amplifiers) that produce heat.
Make sure the cables do not represent a tripping hazard.
Power supply cords should be routed so that they are not pinched by items placed
upon or against them, also avoid sharp bends, pinches and contact with hot surfaces,
paying particular attention to the point that they exit from the unit. Do not allow the
power cord to be pulled.
Do not attempt to operate this unit if the power cord is frayed or broken or if the
appliance has been dropped or damaged or in the unlikely event of product
failure/malfunction.
This product is not intended to be handled –it is essentially a visual product. Some
parts can become warm with use. However, a suitably responsible adult may wish to
access the projector periodically to change effects.
Do not dismantle. Take the projector to a qualified repairer when servicing is required.
To avoid the possibility of inadvertent resetting the thermal cut-out, this appliance
must not be supplied via an external switching device, such as a timer or connected to
a circuit that is regularly switched on or off.
If using an extension cord, a cord with a current rating at least equal to that of the
appliance must be used. Cords rated for less amperage than the appliance may overheat.
Switch off and unplug after use. Pull the plug out gently and with care to disconnect –
do not yank on the cable to unplug.
