orfit RAYCAST 32190 User manual

Page 1 of 2
INSTRUCTIONS FOR USE
RAYCAST®HIGH PRECISION
BASE PLATE-TO-COUCH
TOP FIXATION DEVICES
2-PIN BAR FOR PIN-POINT
COUCH WITH A WIDTH OF
50 CM (MRI COMPATIBLE)
Article No. : 32190
A. GENERAL PRODUCT INFORMATION
This product is a fixation device to attach Raycast High Precision
base plates to couch tops with the pin-point type indexing.
B. PRODUCT DESCRIPTION
This 2-pin bar has two positioning blocks that fit over the
indexing pins on the sides of pin-point style couches with a
width of 50cm exactly. It can be used to index hardware (base
plates, shoulder positioning device, leg indexing system, etc.)
directly or via an adapter plate to the couch. For information on
the compatible products, please refer to the respective
‘instructions for use’.
C. POSITIONING ON A COUCH
The bar is designed for couches with a width of 50cm.
The two blocks of this fixation device have a slot which fits over
the pins of the pin-point style indexing system.
Push the bar over a set of pins until it clicks in place. The bar
itself should now be flat on the surface of the couch. Always
make sure that the bar is well positioned on the couch before
indexing the other hardware.
To remove the bar, hold the two ends of the bar and pull until
the bar snaps off the couch. Never pull in the middle of the bar.
D. STORAGE
Always store the product in a safe place to prevent it from
getting damaged.
Store the product between +10°C (50°F) and 40°C (122°F).
E. PROPERTIES
E.1 Physical Properties
Dimensions : L 546 x W 24 x H 38,5 mm
Weight: +/- 0.1 kg
E.2 Material Properties
Material POM (pins/blocks): 1,4 gr/cm³
Material PC (screws): 1,2 gr/cm³
Material Glass Fibre (bar): 1,8 gr/cm³
This product is made entirely of durable plastics and is MR-safe.
Warning: keep metal wrenches which might be supplied in the
package out of the MRI room.
E.3 Dosimetric Properties
Attenuation factor (± 0.15 %)
6 MV
2.67%
15 MV
2.00%
H2O equivalence
7.72 mm
Note: Use these numbers as a guidance only. Perform the
measurements again in your department to verify these results.
F. MAINTENANCE AND WASTE MANAGEMENT
This product can be cleaned and disinfected by means of soapy
water or an isopropanol based disinfectant, applied with a soft
cloth. If unsure about the cleaning fluid, do not use. Never use
aerosol sprays, corrosive cleaning agents, solvents or abrasive
detergents.
Periodic checks of the product should be done to insure the
parts are not worn and require repair or replacement. Do not
attempt to make repairs yourself. Contact your distributor if
there are any questions or concerns.
The product can be disposed of with household waste.

Note:
It is prohibited to make alterations to this text without prior approval from Orfit Industries.
RAYCAST® is a registered trademark of ORFIT INDUSTRIES.
www.orfit.com
Ref. No. 50026
VERSION 5
LAST UPDATE: 02/04/2021
REVISION DATE: 02/04/2023
Page 2 of 2
G. FIXATION DEVICES COMBINATION PACKAGES
This product is part of following fixation devices combination
packages:
•33140
•33164
•33138
•33162
•33153
•33163
H. ADDITIONAL INFORMATION
For additional information such as distributor contact
information, product brochures, Material Safety Data Sheets
and regulatory information, please visit our website
www.orfit.com.