Ortronics MM6VML706 User manual

125 EUGENE O' NEILL DRIVE
NEW LONDON, CT 06320
PHONE: [phone]
FAX: [phone]
TITLE: 6"x 6" CABLE MANAGEMENT
CAGE FOR MIGHTY MO 6
ECN: DATE:
03/26/04
SHT:
1 OF 5
BY:
S. LEVESQUE
CHK. BY:
D. Bogue
DATE:
03/26/04
APP. BY:
MEM
DATE:
03/26/04
REV:
00
INSTRUCTION SHEET:
71601419
6” x 6” CABLE MANAGEMENT CAGE, MIGHTY MO 6
ASSEMBLY INSTRUCTIONS
STEPS:
1. Before mounting the cable cage, inventory material contents per Sheet 2 of
5 of the instruction sheets.
FIGURE 1 INSTRUCTIONS: Dual rack front mounting.
1. Adjust rack spacing to be 2-1/2” apart. Attach 3 brackets (with hooks pointing up),
starting at the bottom and working up using the #10 x ½” hex washer screws. Place
the last bracket upside down at the top of the cage and place the cage over the
attached brackets and secure the top bracket using the #10 x ½” hex washer head
screws.
FIGURE 2 INSTRUCTIONS: Single rack front mounting.
1. Attach cable cage per Figure 1 (Sheet 3 of 5), using #10 X ½” hex washer head
screws to rack side only.
2. Insert the square plastic nuts into the side of the rack at each bracket location.
3. Secure end support brackets using #10 x ½” hex washer head screws into the nuts.
4. Attach end brackets to cage brackets using #10 x ½” hex washer screws.
FIGURE 3 INSTRUCTIONS:Swing latch replacement installation.
1. Installation can be either right or left hand swing outs.
2. Position latch at end of ring and tap into place with a rubber mallet or piece of wood.
FILE: 716\014191.XLS