oticon Amigo User manual

The Amigo System
Transmitter
On/ off/ mute
LCD display
T
eam teachin
g
(T21 only)
Clear
Synchronize receiver /
Enter
Audio input
j
ack
Microphone
j
ack
Char
g
in
g
j
ack
LED status indicator
Receiver
The receiver’s LED can confirm the following:
•The battery is okay.
•The receiver is on.
•The transmitter and receiver are working
together.
•The child is on the right channel.
Mode Switch
○○ FM and environmental microphone operating
○FM only operating
●Off
The toggle beneath the switch,
available on the R2 receiver is for
older students who may want to
toggle between a number of
different frequencies.
Pin orientation. The LED should point to the
front or back on a bte processor. It is
possible to change the orientation of the pins
by pulling out the plate with the pins on
(there are recesses for finger nails!), turning
the pins and pushing the plate back in.

The Amigo System – How to use it
The transmitter
To turn on the transmitter: hold down the on/off switch on the top
until the red light comes on and the channel number shows on the
screen.
To change the frequency: hold down the ‘up’ cursor key until the
number starts to flash. You can then change the channel using the
up and down cursor keys. To confirm the selection of a channel,
press down the centre sync button.
To mute the transmitter: Press on the on/off button once briefly.
Press again to re-activate the microphone.
To lock the keypad: Press down both left and right arrows together
for three seconds. To unlock do the same.
To listen to a channel: You can use earphones to hear what the child
is hearing through the microphone. To do this, unplug the
microphone and insert the listening headphones into the auxiliary
input socket. This needs to be done using the channel wizard menu.
Details of how to do this can be found in the Amigo Fitting Guide
which is available on line on the Amigo website (www.amigofm.com).
Follow the links to Professionals and then downloads.
To use the team teaching facility (only available on the T21): Press
the TT button. This will provide access to the primary and team
teaching channels. You need to use the channel wizard to set the
channels. Details of how to do this can be found in the Amigo Fitting
Guide which is available on line on the Amigo website
(www.amigofm.com). Follow the links to Professionals and then
downloads.
The receiver
The receiver is powered by the batteries in the processor or adaptor
to which it is attached.
It has an LED light which, when lit constantly, indicates that
everything is working well.
To synchronize the receiver with the transmitter: turn the transmitter
and receiver on. Make sure the receiver is powered. Ensure that the
receiver is 20-40cm away from the transmitter. Press the sync
button in the centre. The LED will flash and then come on
continuously when the correct channel is found.

This system has many features; some of the most useful of which are
listed below. To find information on how to use these features go to:
http://www.amigofm.com/eprise/main/Oticon/com/SEC_Professionals
/ProductInformation/SEC_Amigo/Professionals/Downloads/_index
and download the Amigo fitting guide which gives full details on how
to use the system.
Assigning a name to the transmitter and receiver
Adjusting the FM gain on the receiver
Manual channel change (R2 and R7 receivers)
Disabling the manual channel
Channel Wizard which indicates the optimal channel to be
used in any situation
Setting the team teaching channel using the Channel Wizard