Oypla GARDEN 4195 User manual

Potting Table
User Manual
USER MANUAL Model No: 4195

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
Unpacking, installing and fixing the parts are to be completed by an adult.
Never exceed the maximum load capacity of 9kg per shelf, or it may result in product
failure and/or personal injury.
This product is intended for outdoor use only.
This product is not a toy, and is only to be used for its designated purpose.
Leaving the product outside exposed to weather, especially direct sun and rain, will
speed the weathering process. This can be slowed by removing the product from these
conditions.
Keep away from fire.
Only use this product on stable and level ground.
Do not discard any of the packaging until you have checked that you have all of the
parts and fittings required.
Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened
before use.
If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 4195

Assembly Instructions
PARTS LIST:
NAME
OTY
Shelves (A)
X2
Top Shiny Shelf (B)
X1
Side Panels (C)
X2
Small wooden plank (D)
X2
Large wooden plank (E)
X3
Large Screws (F)
X20
Medium Screws (G)
X14
Small Screws (H)
X12
Hooks (I)
X6
A
E
D
C
B
USER MANUAL Model No: 4195

1) To start, ensure you have all the correct parts and quantities.
2) First, attach one of the shelves (A) to one of the side panels (C) using the
large sized screws (F). Once securely in place, do the same with the
remaining shelf. Repeat this step on the other side, attaching the other side
panel (C). 8 screws should have been used. Please see the photo on the
previous page to help.
3) Now, attach the shiny top shelf (B) on the top the frame build in step 2. Use
4 more large sized screws (F) to securely attach this in place.
4) Next, using the remaining 8 large screws (F) attach 2 of the large wooden
planks (E) to the back of each shelf (middle and lower) as seen on the
previous page.
5) Do the same as the previous step however, use the remaining large
wooden plank (E) on the top shelf and use medium sized screws (G) to
attach this. Then, get both smaller wooden planks (D) and attach using
medium sized screws (G) to each end of the top shiny shelf (B). 14 medium
sized screws are used in this step.
6) Lastly, attach your desired number of hooks wanted on the outer side of
the small wooden planks (D) and securely drill into place using 2 small
screws (I) for each hook.
Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 4195