Oypla Kids Crayon 3852 User manual

User Manual
USER MANUAL Model No: 3852
Crayon Table & Chair Set

•This product is not a toy, and is only to be used for its designated purpose.
•This product is only suitable for children aged three and above.
•Never carry out any alterations or modifications to this product.
•This product is intended for indoor use only.
•Only use this product on stable, level and dry ground.
•Do not exceed the 30kg weight limit for the table and chairs.
•An adult should assess the area that the table and chair set will be placed to
remove any potential hazards.
•Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
•Unpacking, installing and fixing the parts are to be completed by an adult.
•Keep away from fire.
•Make sure all packaging has been removed before attempting to build the
product.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
•If the product is damaged or has any defects, please contact [email protected]
USER MANUAL Model No: 3852
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.

USER MANUAL Model No: 3852
Operating Instructions
Parts List:
If you are missing any of the below parts please contact c[email protected]
Please be aware that you will be referring to this parts list throughout the assembly process.

Please retain a copy of all instructions for future consultation.
USER MANUAL Model No: 3852
1. Lay the chair base on the floor and screw a chair leg
into each hole in the bottom of the chair base. Force may
be required to secure each leg into place correctly and
ensure that the chair will remain stable. Please see the
image to the right.
2. Stand the chair base up and push the chair back poles
onto either side of the chair backboard. After this, align
the completed chair back with the holes in the chair
base, securing this in place with two screws. Once you
have completed this step the chair is fully assembled.
Please see the image to the left. Repeat the first step
and this step to create the other chair.
3. Lay the table top on the flat top side and
screw the table legs into the holes at each
corner of the table top. Force may be required
to secure the legs into place correctly. Please
check the image to the right. Before allowing a
child to use the product, make sure an adult
has checked over the whole product.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX