Panasonic KX-TG8301FX User manual

PNQW1121ZA DC0408DE0 FX-2
Connections
Important:
LIf you use a telephone line cord which is not supplied, the unit may not work
properly.
Base unit
(220-240 V AC, 50 Hz)
To telephone
line
DSL/ADSL filter
(For DSL/ADSL service users)
Use only the supplied Panasonic
AC adaptor PQLV207CE.
Use only the supplied
telephone line cord.
Press plug firmly.
“Click”
“Click”
Hook
Hook
(KX-TG8302)
Charger
Use only the supplied Panasonic
AC adaptor PQLV209CE.
Press plug firmly.
(220-240 V AC, 50 Hz)
Hooks
Model No. KX-TG8301FX/KX-TG8302FX
KX-TG8321FX
Quick Guide
To use this unit in your country, first change the unit’s region setting to match your
country. Change the unit’s display language as needed.
Refer to “Changing the unit’s region setting” in the operating instructions.
TG8301_8321FX(e)_QG.fm Page 1 Tuesday, April 1, 2008 11:06 AM

– 2 –
Battery installation/Battery charge
Charge for about 7 hours.
Note:
LUSE ONLY Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
Screen saver mode
The backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base
unit or charger.
Activate the handset display again by:
– pushing the joystick left {<}or right {>}
when on a call.
–pressing{ih} at all other times.
Base unit *1 Charger *2
Rechargeable
Ni-MH ONLY
“Charging”will
be displayed.
*1 Model shown is KX-TG8301.
*2 KX-TG8302
{ih}
{<}, {>}
TG8301_8321FX(e)_QG.fm Page 2 Tuesday, April 1, 2008 11:06 AM

– 3 –
Operating tips
Using the joystick
The handset joystick can be used to navigate
through menus and to select items shown on
the display by pushing it up {^}, down {V},
left {<}, or right {>}.
To adjust the receiver or speaker volume,
push the joystick up to increase the volume,
or down to decrease the volume repeatedly
while talking.
Soft keys
The handset features 2 soft keys and a
joystick. By pressing a soft key, or by
pressing the centre of the joystick, you can
select the feature shown directly above it on
the display.
Menu icons
When in standby mode, pressing down on the centre of the joystick reveals the
handset’s main menu. From here you can access various features and settings.
*1 KX-TG8301/KX-TG8302
*2 KX-TG8321
Display language (Handset) (default: English)
16 display languages are available.
You can select “Deutsch”, “English”, “Magyar”, “Polski”, “SlovenČina”,
“ČeŠtina”, “Hrvatski”, “Slovenscina”, “Eesti”, “LIETUVIŠKAI”,
“LatvieŠu”, “Românã”, “БЪЛГАРСКИ”, “Srpski”, “МАКЕДОНСКИ”, or “Shqip”.
1K(centre of joystick) iNiM
2{V}/{^}: “Display Setup”iM
3{V}/{^}: “Select Language”iM
4{V}/{^}: Select your desired language. iMi{ih}
Note:
LIf you select a language you cannot read: {ih} iKiNiMi
Push the joystick down 2 times. iMiPush the joystick down 4 times. i
Mi{V}/{^}: Select your desired language. iMi{ih}
Volume up
Volume down
Icon Feature
jCaller List
XSMS (Short Message
Service)
KTime Settings*1
Icon Feature
IAnswer System*2
NHandset Setup
!Base Unit Setup
#Incoming No. Bar
TG8301_8321FX(e)_QG.fm Page 3 Tuesday, April 1, 2008 11:06 AM

– 4 –
Dialling mode (Handset) (default: Tone)
1K(centre of joystick) i!iM
2{V}/{^}: “Dial Mode”iM
3{V}/{^}: Select the desired setting. iMi{ih}
Date and time (Handset)
1K(centre of joystick) iNiM
2{V}/{^}: “Time Settings”iM
3{V}/{^}: “Set Date & Time”iM
4Enter the current date, month, and year.
5Enter the current hour and minute.
6Mi{ih}
TG8301_8321FX(e)_QG.fm Page 4 Tuesday, April 1, 2008 11:06 AM

– 5 –
Basic operations
Making/Answering calls (Handset)
Making calls Dial the phone number. i{C}/{s}
Answering calls {C}/{s}
To hang up {ih}
To adjust the receiver/
speaker volume
Push the joystick up or down repeatedly while
talking.
Making a call using the redial
list
j(right soft key) i{V}/{^}: Select the desired
phone number. i{C}/{s}
Temporary tone dialling
(for rotary/pulse service
users)
1Make a call.
2Press {*} when prompted to enter your code or
PIN, then press the appropriate dial keys.
Handset ringer volume 1K(centre of joystick) iNiM
2{V}/{^}: “Ringer Setup”iM
3{V}/{^}: “Ringer Volume”iM
4{V}/{^}: Select the desired volume. iMi
{ih}
Phonebook (Handset)
Adding entries 1n(left soft key) iK
2{V}/{^}: “New Entry”iM
3Enter the party’s name (16 characters max.). i
M
4Enter the party’s phone number (24 digits max.).
iM
5{V}/{^}: Select the desired category. iM
2timesi{ih}
LTo enter a name, see the character table in the
operating instructions.
Making calls 1n(left soft key)
2{V}/{^}: Select the desired entry.
LYou can scroll through the phonebook entry by
pushing and holding the joystick down or up.
3{C}
Answering system (Base unit): KX-TG8321
Answering on/off Press {s}to turn on/off the answering system.
Listening to messages {6}
TG8301_8321FX(e)_QG.fm Page 5 Tuesday, April 1, 2008 11:06 AM

– 6 –
Frequently asked questions
Question Cause/solution
Why is wflashing? LThe handset is too far from the base unit. Move
closer.
LThe base unit’s AC adaptor is not connected.
Check the connections.
LYou are using the handset or base unit in an area
with high electrical interference. Place the base
unit and use the handset away from sources of
interference.
LThe handset is not registered to the base unit.
Register it (page 8).
Why can I not make calls? LThe dialling mode may be set incorrectly. Change
the setting (page 4).
Why is the handset display
blank or goes dark when on
a call?
LThe handset is in screen saver mode. Activate the
handset display again by:
– pushing the joystick left {<}or right {>}when
on a call.
– pressing {ih} at all other times.
L“LCD Dimming”is set to “Off”while on charge.
Change the setting.
What should I do when the
handset does not turn on?
LMake sure the batteries are installed correctly.
LFully charge the batteries.
LClean the charge contacts and charge again.
How long is the battery
operating time?
LWhen you are using fully-charged Ni-MH batteries
(supplied batteries);
In continuous use: 15 hours max.
Not in use (standby): 250 hours (10 days) max.
LIt is normal for batteries not to reach full capacity
at the initial charge. Maximum battery
performance is reached after a few complete
cycles of charge/discharge (use).
LActual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
Can I keep the handset on
the base unit or charger
when I am not using it?
LEven after the handset is fully charged, the
handset can be left on the base unit or charger
without any ill effect on the batteries.
When should I replace the
batteries?
LIf the batteries are fully charged until & is
displayed, but
) is displayed after a few calls,
replace the batteries with new ones.
TG8301_8321FX(e)_QG.fm Page 6 Tuesday, April 1, 2008 11:06 AM

– 7 –
What is a PIN? LThe PIN is a 4-digit number that must be entered
in order to change certain base unit settings. The
default PIN is “0000”.
What should I do to display
caller information?
LYou must subscribe to a Caller ID service. Contact
your service provider/telephone company for
details.
LThe message “You must first subscribe
to Caller ID.” will be displayed until you
receive caller information after subscribing to a
Caller ID service.
What should I do when noise
is heard, sound cuts in and
out?
LYou are using the handset or base unit in an area
with high electrical interference. Place the base
unit and use the handset away from sources of
interference.
LMove closer to the base unit.
LIf you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base
unit and the telephone line jack. Contact your
DSL/ADSL provider for details.
What should I do when the
operating time seems to be
shorter even after I fully
charged the batteries?
LClean the battery ends (S, T) and the charge
contacts with a dry cloth, and charge again.
What do I need to do to
erase W(Missed call) from
the display?
LThere are unviewed missed calls remaining. View
them using the following method.
1K(centre of joystick) ijiM
2Push the joystick down to search from the most
recent call, or push the joystick up to search
from the oldest call.
Frequently asked questions
Question Cause/solution
TG8301_8321FX(e)_QG.fm Page 7 Tuesday, April 1, 2008 11:06 AM

– 8 –
Registering a handset to a base unit
The supplied handset and base unit are pre-registered. If for some reason the
handset is not registered to the base unit, register the handset.
1K(centre of joystick) iNiM
2{V}/{^}: “Registration”iM2 times
3{V}/{^}: Select a base unit number. iM
Proceed with the operation for your model.
NKX-TG8301/KX-TG8302
Press and hold {x} for about 5 seconds.
(No registration tone)
NKX-TG8321
Press and hold {x} for about 5 seconds, until
the registration tone sounds.
LThe next step should be completed within
90 seconds.
Wait until “Enter Base PIN”is displayed. i
Enter the base unit PIN (default: “0000”). i
M
LWhen the handset has been registered
successfully, wstops flashing.
Handset
M
Base unit
{x}
{x}
Handset
M
TG8301_8321FX(e)_QG.fm Page 8 Tuesday, April 1, 2008 11:06 AM

– 9 –
Optional services (Caller ID and SMS)
If you subscribe to a Caller ID service, you can:
– display caller information
– identify who is calling by using different display colours and
ringer tones (phonebook category)
To use SMS, you must subscribe to a Caller ID and/or an appropriate service.
– SMS (Short Message Service)
012345
012345
TG8301_8321FX(e)_QG.fm Page 9 Tuesday, April 1, 2008 11:06 AM

– 10 –
Notes
TG8301_8321FX(e)_QG.fm Page 10 Tuesday, April 1, 2008 11:06 AM