Panasonic ER131 User manual

© 2007 Matsushita Electric Works, Ltd. All rights
reserved. Unauthorized copying and distribution is a
violation of law.
Order Number SD0704R34CE
AC/Rechargeable Hair Clipper
Model No. ER131
Russia
TABLE OF CONTENTS
PAGE PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 4
5 Wiring Connection Diagram ---------------------------------- 6
6 Schematic Diagram ---------------------------------------------- 6
7 Exploded View and Replacement Parts List ------------ 7

2
1Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100°F / 600°C).
2 Specifications

3
3 Troubleshooting Guide

4
4 Disassembly and Assembly Instructions
4.1. Disassembly Instructions
Follow the procedure below to disassemble the main body.
1. Remove the attachment and the blade.
2. Loosen two screws tightening the blade springs and two housing screw.
3. Separate housing A and B by opening at the blade side.
4. Take out the motor and module from housing A.
5. Unsolder the lead wires and separate the motor from the module.
6. Remove the switch handle.

5
4.2. Assembly Instructions
1. Connect the motor with the lead wire.
NOTE:
Motor has its own direction on assembly. Place the label side on top.
2. Confirm both switch handle and switch contact block are set OFF position. Place the motor and module assembly into the
Housing A.
3. Make sure that the plug chassis and motor are assembled properly and connect with adaptor. Confirm if the motor rotates
when turning the switch ON.
4. Tighten four screws with Housing A and B.

6
5 Wiring Connection Diagram
6 Schematic Diagram

7
7 Exploded View and Replacement Parts List
7.1. Exploded View
7.2. Replacement Parts List
Safety Ref. No. Part No. Part Name & Description Quantity Remarks
1 WER131H7399 COMB ATTACHMENT A 1 (3/6mm) <BG>
2 WER131H7409 COMB ATTACHMENT B 1 (9/12mm) <BG>
3 WER9181Y BLADE BLOCK 1
4 WER850B9006 SCREW 4 (K2-8) <BG>
5 WER131H3059 HOUSING A 1 <BG>
6 WER131H3209 SWITCH HANDLE 1 <BG>
7 WER131L0058 CONNECTING PLATE 1 <BG>
8 WER131H3069 HOUSING B 1 <BG>
9 WER145L1006 MOTOR 1 <BG>
10 WER131L2508 RECHARGEABLE BATTERY 1 (Ni-Cd Type) <BG>
11 WER131L2109 MODULE 1 <BG>
12 WER131K7664 CHARGING ADAPTOR 1 (C-2 PLUG) <BG>
13 WES76806766 CLEANING BRUSH 1 <BG>
14 WER203X7916 OIL 1 <BG>
- WER131H8009 INDIVIDUAL BOX 1 <BG>
- WER131H8109 OPERATING INSTRUCTIONS 1 <BG>