Instructions
I
IM
MP
PO
OR
RT
TA
AN
NT
T
I
IN
NF
FO
OR
RM
MA
AT
TI
IO
ON
N
R
RE
EG
GA
AR
RD
DI
IN
NG
G
U
UN
NI
IT
T
P
PL
LE
EA
AS
SE
E
N
NO
OT
TE
E:
:
oPrior to lighting the heater, ensure that the protective plastic coating from
the stainless steel parts has been removed.
oDo not place articles on or against this appliance.
oDo not spray aerosols in the vicinity of this appliance.
oDo not use or store flammable materials near this appliance.
oDo not operate with covers or panels removed.
oChildren and adults should be alerted to the hazards of high surface
temperatures, burns and clothing ignition.
oYoung children should be carefully supervised when they are in the area of
the appliance.
oClothing or other flammable materials should not be hung from the
appliance, or placed on or near the appliance.
oAny guard or other protective device removed for servicing the appliance
must be replaced prior to operating the appliance.
oInstallation of appliances fitted to fixed gas supply systems and repair of all
appliances must be carried out by a qualified service person.
oIt is imperative that control compartment, burners and circulating air
passageways of the appliance be kept clean.
oNot recommended for installation in areas with a salt-laden atmosphere.
WARNING!
This heater must be installed to the requirements of gas
code AS 5601 and to the requirements of the local
authorities both gas and electrical.
WARNING!
This heater needs 240 VAC power.
WARNING!
This appliance must be installed with the correct pipe size
and gas pressure to operate correctly.
The gas installer must ensure that the gas piping is of
adequate size to ensure correct pressure and volume suited
for the burners.
The burner pressure should be checked when all the gas
equipment on the site is operating.
