ParaZero SafeAir M200 User manual

SafeAir M-200
TerminateAir Update
Instructions

SafeAir™ M-200 TerminateAir Update 2 www.parazero.com
1. Connecting the TerminateAir to the drone with
the new quic release pin
1 The TerminateAir is the red
colored flight termination
system, which is mounted
abo e the DJI M-200 battery
compartment. It is designated
to stop the power to the rotors,
should a critical malfunction
occur.
2 Disconnect the right long
screw that connects the
TerminateAir to the drone,
using the supplied toolset.
3 Turn the TerminateAir to the left
using the left long screw as a
pi ot.
4 Insert the quick release pin,
while aligning its plate, in order
to connect the TerminateAir to
the right arm. Then press the
pin against its spring and rotate
the plate to the horizontal
position. This will secure the pin
in place.
5 Be sure that the lever that is on
the lower part of the
TerminateAir is in its down
position, to hold the batteries
from falling in case of
emergency activation of the
system. If it is not, push the
small knob towards the right
and then push the le er
downwards until it is locked.
Lever
Releasing nob

SafeAir™ M-200 TerminateAir Update 3 www.parazero.com
2. Replacing the batteries
1 In order to replace the
batteries, remo e the quick
release pin, by pressing it first
against its spring to align the
plate. Turn the TerminateAir to
the left around its pi ot. After
replacing the batteries turn the
TerminateAir back to its place,
insert the quick release pin,
while aligning its plate. Then
press the pin against its spring
and rotate the plate to the
horizontal position. This will
secure the pin in place.
2 Once a week, tighten the left
long screw using the pro ided
toolset.
Caution
Make sure that the le er is always
positioned in its lower position.
Fly Safely!
Should you ha e questions, contact our support team at –
[e-mail]
Phone – [phone]
Lever
Releasing nob

Tel – [phone]
30 Dov Hoz
Kiryat Ono, Israel 5555626
www.parazero.com
Operate Drones Everywhere, Safely