Parrot Products IW7103 User manual

Tel: (RSA) 010 140 4900 / Email: [email protected] / www.parrot.co.za
For further information, please visit / contact us on:
IW7103: Interactive Touch Panel Mobile Stand

2.5 inch universal casters (hole spacing 51*35)
Base
M10*70 screw foot cup
Mobile bracket body
Wall crossbeam
Wall vertical beam
M5*100 Screw
M6*16 cross hexagon head combination bolts
M8*20 hexagon bolt
M8 spring washer (GB859)
M8 at washer (Gb848)
hexagonal wrench
1
4
4
1
1
2
2
16
13
13
13
1
Assembly with base
Assembly with base
Assembly with base
Assembly with body
Assembly with crossbeam
Assembly with vertical
beam
Assembly with base
Assembly with base
and body
Assembly with base
and body
Assembly with base
and body
Assembly hexagon bolts
Description Quantity/PCS Position
Wall crossbeam
Wall vertical beam
Mobile bracket body
2.5 inch universal casters
Base
M10*70 screw foot cup 1

Base
Figure A
2.5 inch universal caster
(hole spacing 51*35)
(Quantity: 4PCS)
M10*70 screw foot cup
(Quantity: 4PCS)
M6*16 cross hexagon head
combination bolts
(Quantity: 16PCS)
Use screwdriver & hexagon head combined with
M6*16 bolts to assemble the caster wheels to the base
Directly lock the foot cups to the corresponding
position of the base See Figure A
Figure B
Mobile bracket body
Hexgon bolt m8*20, M8
spring washer, M8 at
washer (Quantity: 9PCS)
Partial view of assembly location
Put M8*20 hex bolts on M8 spring washer and M8 at washer in turn, take out the main body of the mobile bracket
from the packing box and assemble with the hex wrench and M8*20 hex bolt to the base of the assembled caster
and foot cup, pay attention to the direction.
Hexagon bolt M8*20, M8 spring washer, M8 at washer
(Quantity: 4PCS)
Wall crossbeam
(Quantity: 1PCS)
Figure C
Use a hexagonal wrench an M8*20 bolts with spring washersand at washers to assemble the main body of the
moving bracket
2

Please Note:
# In order to correctly guide the installation of the mobile stand for the conference, please read the instructions
carefully when installing
#Please entrust a professional installation company to install the mobile stand for this conference
#If you don't understand anything while reading this manual please contact us for assistance
#The illustrations in this manual are for reference only, Please refer to the actual products
Figure D
Wall vertical beam
(Quantity: 2PCS)
M5*100 screw
(Quantity: 2PCS)
Wall bracket assembly diagram front
Partial View
B
Partial View
B
Rotate the M5*100 screw on the wall
mounted vertical beam to the position
shown in partial gure and then assemble
the wall mounted vertical beam to
the machine
Hang the machine with the vertical beam installed, then mount it on the wall, then use a screwdriver to
lock the M5*100 screws to the wall mount beam
3