PBA Safety Speakman SE 607 Operating and maintenance manual

ISO 9002
Lic QEC13179
FREE CALL 1 800 444 022
www.pbasafety.com.au
2134 1753 1650
1090
25mm
Ø 12mm
4 places
25mm
SE - 607
Installation, Maintenance and Operating Instructions
DESCRIPTION
SPECIFICATIONS
SHOWER EYE WASH
SHOWER HEAD
VALVE
ACTIVATOR
- 200mm ABS Cycolac
- 25mm Stainless Steel
- 304 Stainless Steel Tube
EYE/FACE WASH
VALVE
ACTIVATOR
STANCHION
BASE PLATE
FOOT PEDAL ASSEM
- Aerated, ABS Cycolac S/S Inserts
- 12mm Stainless Steel
- 304 Stainless Steel Paddle Handle
- 304 Stainless Steel Tube
- 304 Stainless Steel
- 304 Stainless Steel Tube
NOTE : This unit should be connected to an uninterrupted source of potable water, no less than
25mm (1"), with a minimum flowing pressure of 130KPa and a maximum static pressure of 860 KPa.
FLOW DATA
FLOW PRESSURE (KPa) : 34 69 103 138 172
FLOW RATE (LPM) : 76 76 76 76 76
SHOWER
FLOW PRESSURE (KPa) : 136
FLOW RATE (LPM) : 36
EYE-WASH
Base Plate
Details
INSTALLATION
After unpacking carton, ensure all components are present. Mark out the floor and mount the bottom
stanchion section using suitable anchors (10-12mm x 50 Dynabolt). Then assemble top section (use
pipe sealant on all joints). Assemble pull rod and shower head, attach paddle handle and foot pedal.
Once the unit is completely assembled connect water supply to 32mm top inlet nipple. Failure to use
potable water can result in emergency units producing impure or contaminated water causing
possible further injury.Test unit.
OPERATION
The shower is activated by pulling the triangle pull rod. Once the valve is activated the head will
continue to discharge water until the valve is manually closed, this is done by pushing the pull rod to
the off position.
The eye wash is activated by pushing the paddle
handle rearward. The unit will operate until the
paddle handle is manually pulled to the off position.
150mm
150mm
Floor mounted EMERGENCY DELUGE SHOWER and AERATED EYE/FACE WASH combination
unit. Shower is supplied with a 25mm stay open full flow ball valve, activated by a triangle pull rod.
Eye/Face wash is supplied with a 15mm stay open full flow ball valve,activated by a activation
paddle handle or foot pedal.
ON
ON PositionOFF Position
OFF
SE 607
Combination Deluge Shower & Eye/Face Wash
SPEAKMAN
SAFETY PRODUCTS
R

ISO 9002
Lic QEC13179
FREE CALL 1 800 444 022
www.pbasafety.com.au
SE 607 SPARE PARTS LISTING
ill.1029 (SE 607 S/P)
SPEAKMAN
SAFETY PRODUCTS
R
SE 607
Combination Deluge Shower & Eye/Face Wash
11
10
12
9
5
6
15
13
14
4
7
8
No. DESCRIPTION PART No.
1Aerator Sreen Assembly
2Aerator Screen Assembly & Cap 05 1177 PC
G05 0384
3Shroud Assembly Repair Kit (1 side) G10 0041
4Shroud Body & Aerator Assy. (1 side ) G10 0042
512mm Activation Ball Valve & Push Handle SE 910V
6200mm Cycolac Shower Head SE 870
7
8Combination Frame SE FRAME
925mm Acitvation Ball Valve & Handle SE 911
10 Foot Pedal Connect Rod SA 03003
11 Foot Pedal Activator Assembly
Pull Rod Assembly
Stainless Steel Bowl
Strainer Gauze
SE TREADLE
Inline Filter Assembly G21 0082
G21 0080
12
13
14
15
Shower Arm 25mm BSP SC 02001
SA 02008
68 0033
1
2
3
4
11
PULL-ON
SPEAKMAN EMERGENCY SHOWERS
Aerator Screen Assembly & Cap
Part No - 05 1177 PC
Aerator Screen Assembly
Part No - G05 0384
Complete Shroud Assembly
Part No - G10 0042
Supply Line Strainer Assembly
Part No - G21 0082 PCP
Shroud Maintenance Kit
Part No - G10 0041
WARNING : Use only genuine Speakman parts when replacing or repairing
components. When ordering quote correct part numbers listed below.
To order free call 1 800 444 022 or free fax [phone]