PDi PD168-084 User manual

MODEL NUMBER:
PD168-084 Table Stand
Document Number:
PD196-435R1
Installation Instructions
Page 1 of 3
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ www.pdiarm.com and www.mymedTV.com ▪ Phone [phone]
INTRODUCTION
This document provides the information to assemble and install the PD168-084 Table Mount kit for the A
Series TV’s (A24A, A32A, A43A, & A55B).
SAFETY
1. Always wear safety glasses/goggles to prevent injury from debris.
2. Follow the installation/removal instructions for your existing products.
TOOLS REQUIRED
1. Phillips screwdriver
2. 7/16” and 1/2” wrench
3. Safety glasses/goggles
INSTALLATION
Included Hardware:
Assemble Supports:
1. This step is not required for the A24A and A32. Assemble the right (Aand C) and left Uprights (Band D)
together using the nylon locking nuts J. Tighten the nuts with wrench L. See Figure 1.
2. Assemble the left and right base subassemblies (Left and Right are defined when viewing the TV when
watching the TV.). See Figure 2.
a. Right: Assemble bracket Eto Bracket Gwith two (2) of Screw I, using Wrench K.
b. Left: Assemble bracket Fto Bracket Hwith two (2) of Screw I, using Wrench K.

MODEL NUMBER:
PD168-084 Table Stand
Document Number:
PD196-435R1
Installation Instructions
Page 2 of 3
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ www.pdiarm.com and www.mymedTV.com ▪ Phone [phone]
3. Attach the Uprights to the base sub-assemblies as shown in Figures 3a or 3b by selecting the desired
mounting holes in the uprights, depending on the size of the TV. For the A55B and A43A, use Figure 3a,
and for the A24A and A32A, use Figure 3b.Attach with two (2) of Screw I, using Wrench K.
Note: Be sure to connect the right upright to the right base and left upright to the left base.
4. Attach the assembled brackets to the TV using the appropriate screws included with the base. Refer to
the instructions include with the TV for the appropriate screw diameter. Depending on the TV and the
location of the mounting screw(s), select the backer plate and/or spacers as needed. See Figures 4 & 5.

MODEL NUMBER:
PD168-084 Table Stand
Document Number:
PD196-435R1
Installation Instructions
Page 3 of 3
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ www.pdiarm.com and www.mymedTV.com ▪ Phone [phone]
WARRANTY
PDi Communication Systems Inc., (“PDi”) standard warranty information is found at pdiarm.com. For information
regarding authorized servicing and all other information pertaining to this warranty, please contact PDi
COMMUNICATION SYSTEMS, INC. at 40 Greenwood Ln, Springboro, Ohio 45066 or phone [phone] and
ask for the PDi ProServices team.