PEAKTOP PT-OF0003 User manual

3PCS MOTION SWIVEL SET
PT- OF0003

FIGURE 1
PT- OF0003
PARTS LIST
MATERIAL CODE PART Q’TY
PART
NO. MATERIAL CODE PART Q’TY
PART
NO.
1
2
3
4
5
6
7
8
AT5047-58-01
BASE ASSEMBLY
SEAT POST
WASHER d6.5*D30*3.0
WASHER
SEAT ASSEMBLY
9
10
11
12
1
1
1
8
4
4
2
1
1
Attention:
Make sure that each bolt needed for all steps
matches the corresponding figure to ensure proper
assembly.
PAGE 1 OF 2
48
1
4
4
6
6
6
6
9
9
5
3
1
Step 1:
Place the seat assembly (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
upwards. Fasten the seat post (#3) to the brace of
the seat assembly (#1) by using bolts (#4),
washers (# ,#7 and #9) and jam nuts (# ).
See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the swivel rocker
chair is completely assembled.
Do not discard of any of the packaging until you have checked that you have all of the parts
and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed
by children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
!
!
!
4
AT5047-58-02
AT5047-58-03
AT5047-58-04
AT5047-58-05
AT5047-58-06
AT5047-58-07
1
BOLT M8*48
JAM NUT M8*1.25
WASHER d8.5*D17*1.6
WASHER d8.5*D12*2.1
AT5047-58-08
AT5047-58-09
AT5047-58-10
AT5047-58-11
AT5047-58-12
BOLT M6*40
NUT WRENCH
HE KEY WRZNCH 6MM
7
7
53
#4 BOLT M8*48
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.

FIGURE 2
PAGE 2 OF 2
2
3
10
8
Step 2:
Insert the seat post (#3) into the hole located in
the center of the base assembly (#2). Fasten
them together by using bolt (#10) and washer
(#8). Make sure that all of the bolts have been
tightened completely.See Figure 2.
Note:
For ease with installation, we recommend that the
seat post (#3) be slightly oiled or waxed before
fastening to the base assembly (#2).
Caution:
To ensure one’s safety during use of this
swivel rocker chair, examine all of the bolts
to make sure that they are securely
fastened. This is a chair with swivel rocker
ability; therefore, use by young children
should be adult supervised.
FULL ASSEMBLY
#10 BOLT M6*40
Step 4:
See Full Assembly.
Cleaning and Maintenance
• Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach, acid, or
other solvents on the frame parts.
• We recommend the use of furniture covers when not in use.
• Inspect and tighten all bolts and fasteners on a regular basis to ensure the proper performance and safety of
your swivel rocker chair.
• In order to prolong the life and beauty of your swivel rocker chair, we recommend that it be stored in a dry and
protected area during off season periods.