PEGAS BeerCase User manual

BeerCase
WHAT IS BEERCASE
Pegas BeerCase is designed for safe
filling of carbonated beverages in glass
bottles of 0,7 - 1 liter volume. Maximum
bottleneck diameter that is supports is
39 mm. BeerCase is compatible with all
foam-free taps listed on our website.
Please read the whole document before
setting up the device.
DIMENSIONS
Total height –310mm
Total width –135mm
BEERCASE
MANUAL
Package content
Bottom flask
Upper flask
Centering rubber
ring

BeerCase
RECOMENDATIONS
Put a glass bottle into the bottom flask. Make
sure that bottle easily fits the flask and does not
stuck.
Before use please check the rubber centering ring
is properlyset in the neck of the upper flask.
In case of bottle breakage inside the BeerCase
during the filling it is recommended to replace
BeerCase with the new one, as it could get
damaged with bottle fragments and is no longer
safe for further fillings.
Use of BeerCase with cracks, chipping or deep
scratches is prohibited.
Please wash Pegas BeerCase after every use, and
maintain itclean.
Takeaway b

BeerCase
SET UP INSTRUCTIONS
Step 1
Put a bottle into the bottom
flask
Step 2
Cover the bottle with upper
flask until the bottleneck
touches the centering ring
Step 3
Press the bottle turning
upper flask clockwise
Step 4
Put BeerCase in any Pegas filling
tap and start filling according to
the tap’s instructions
Step 5
When the bottle is filled, remove
the BeerCase and put it on the
flat surface
Step 6
Remove the upper flask, take the
bottle out of the bottom flask,
seal the bottle with a cap

BeerCase
vyu
SAFETY WARNING
Please inspect glass bottle for possible
damages: cracks, scratches, chipping,
etc., as this may lead to bottle
breakage during the filling using
pressurized gas
PLEASE DO NOT USE DAMAGED
BOTTLE OR CASE
NOTE
If, when closing the PEGAS BeerCase, the upper and
lower flasks abut each other with a thread, adjust
the upper flask to align the thread and press the
bottle down, then turn upper flask clockwise. The
bottle should be firmly pressed against the centering
rubber ring inside the PEGAS BeerCase.
Do not tilt PEGAS BeerCase with full bottle inside
when holding and disassembling it as it may lead
to beverage leak.